Kaba Mauer Vary 73071 Operating Instructions

Operating Instructions
73071 Vary – 73073 Vary Flex
1 Important Instructions
The locking mechanism works smoothly. No force should be applied. This should be particularly avoided when inserting
•
the key in the lock.
The locking mechanism can only be changed over to another pair of keys if a valid key is still available. The lock should be
•
converted to a new pair of keys immediately if a key is lost.
Opening the lock with a damaged key can result in damage to the lock.
•
The function of the lock could not be secured, if you use damaged or heavily worn out keys. We recommend to check the
•
condition of the keys before using them and to not use or, if necessary, to change the keys, if they are damaged or heavily
worn out.
The lock must not be lubricated.
•
The lock may only be installed by specialist personnel and only opened by the manufacturers. Unauthorised opening will
•
lead to invalidation of any guarantee claims.
Only original Kaba Mauer keys are to be used should additional keys be required, as otherwise no guarantee claims may
•
be raised.
2 Opening
Insert key in the keyhole as specified in the table below and turn in the appropriate direction until stop position is reached.
•
Lock Installation Position
Bolt left, keyhole horizontal
Bolt down, keyhole vertical
Bolt up, keyhole vertical
Long bit
Diagram 1: Key
Version 73071: The key cannot be removed when the lock is open.
•
Version 73073: The key can be removed when the lock is open.
•
3 Locking
Turn the key back to the original position.
•
The key is to be removed after locking and kept in a safe place where it is not accessible to unauthorised persons.
•
4 Changing over (version 73071 Vary)
Insert the key in the keyhole and turn it until stop position is reached (approx. 130° ), (see 2 or diagram 3).
•
Press the sprung conversion pin in the base of the lock casing until stop (see diagram 2).
•
Diagram 2: Conversion pin
!
Key Insertion Position
Long bit left
Long bit down
Long bit up
Direction of Turn
Clockwise
Clockwise
Clockwise
Revision level 06.06.2008
Page 1