M-system R7G-SC-SHL Instruction Manual

Advertisement

INSTRUCTION MANUAL
GATEWAY MODULE
BEFORE USE ....
Thank you for choosing M-System. Before use, please check
contents of the package you received as outlined below.
If you have any problems or questions with the product,
please contact M-System's Sales Office or representatives.
■ PACKAGE INCLUDES:
Gateway module ..................................................................(1)
■ MODEL NO.
Confirm Model No. marking on the product to be exactly
what you ordered.
■ INSTRUCTION MANUAL
This manual describes necessary points of caution when
you use this product, including installation, connection and
basic maintenance procedures.
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
MODEL
POINTS OF CAUTION
■ POWER INPUT RATING & OPERATIONAL RANG
• Locate the power input rating marked on the product and
confirm its operational range as indicated below:
24V DC rating: 24V ±10%, approx. 1.8W
■ GENERAL PRECAUTIONS
• Before you remove the unit or mount it, turn off the power
supply for safety.
• DO NOT set the switches on the module while the power
is supplied. The switches are used only for maintenance
without the power.
■ ENVIRONMENT
• Indoor use.
• When heavy dust or metal particles are present in the
air, install the unit inside proper housing with sufficient
ventilation.
• Do not install the unit where it is subjected to continuous
vibration. Do not subject the unit to physical impact.
• Environmental temperature must be within -10 to +55°C
(14 to 131°F) with relative humidity within 30 to 90% RH
in order to ensure adequate life span and operation.
■ WIRING
• Do not install cables close to noise sources (relay drive
cable, high frequency line, etc.).
• Do not bind these cables together with those in which
noises are present. Do not install them in the same duct.
■ AND ....
• The unit is designed to function as soon as power is sup-
plied, however, a warm up for 10 minutes is required for
satisfying complete performance described in the data
sheet.
R7G-SC-SHL
EM-7817-A Rev.2 P. 1 / 7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the R7G-SC-SHL and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for M-system R7G-SC-SHL

  • Page 1 MODEL BEFORE USE ..POINTS OF CAUTION Thank you for choosing M-System. Before use, please check ■ POWER INPUT RATING & OPERATIONAL RANG contents of the package you received as outlined below. • Locate the power input rating marked on the product and...
  • Page 2: Component Identification

    Setting “m” with the rotary switches, the addresses are as- signed to m, m+1 for CH1, CH2 respectively. Station Address Setting (x1) Station Address Setting (x16) EM-7817-A Rev.2 P. 2 / 7 5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp...
  • Page 3: Operating Mode

    Baud Rate Setting ■ TERMINATING RESISTOR To use the terminating resistor, turn the switch ON, and OFF to invalidate. (Factory setting OFF) EM-7817-A Rev.2 P. 3 / 7 5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp...
  • Page 4 TXD+ SLD1 SLD1 SLD1 Half-duplex communication Master Module Slave Module Slave Module Terminating Resistor Terminating Resistor TR– TR– TR– SLD1 SLD1 SLD1 EM-7817-A Rev.2 P. 4 / 7 5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp...
  • Page 5: Status Indicator Led

    Unused RY(n+3) {(100+2m) +3}H {(100+2m) +2}H n: CC-Link station address selected with rotary SW. m: HLS module address selected with rotary SW. EM-7817-A Rev.2 P. 5 / 7 5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp...
  • Page 6: Terminal Connections

    Recommended cable connector: TM21P-88P POWER (IN) COMMUNICATION RXD+ (Hirose Electric) (not included in the package) (OUT) RXD– 24V DC POWER (OUT) SLD1 EM-7817-A Rev.2 P. 6 / 7 5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp...
  • Page 7 HA+7 0000 | 0000 | 0000 | 0111 0000 | 0000 | 0000 | 0111 CC-Link received data is fixed. HA+8 CA+2 EM-7817-A Rev.2 P. 7 / 7 5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp...

Table of Contents