Advertisement
PAD20MXU
Please read these operating instructions carefully prior to operation
and keep them for future reference.
1 2
15
17
19
16
18
1. Operating Elements and Connections
1. Mono Input MIC IN (bal.) to connect a microphone to channel CH 1 via XLR
plug or 6.3mm plug. At the XLR jack, a phantom power of +18 V is always
present.
2. Stereo Input LINE IN (RCAjacks) to connect an audio source with line signal
level (e.g. CD player) to channel CH 2/3.
3. Stereo Input TAPE IN (RCA jacks) to connect the output of a recorder
4. Stereo Output TAPE OUT (RCA jacks) to connect the input of a recorder
5. USB port (type B) to connect a computer or a power supply unit with USB
connection; when operating the mixer with a computer, it is possible to use this
port as an audio output (mixed signal output) and as an audio input (feed-in of
audio data to be reproduced via channel Ch2/3)
www.PyleUSA.com
3
4
5
6
7
8
9
10
11
12
13
14
21
23
20
22
2
6. Power/Charge LED ON/CHARGE
• Not Lighting Up: During battery operation of the unit and when the unit is
switched OFF and connected to a power supply and the battery is fully charged.
• Shows Green: When the unit is switched OFF and connected to a power
supply and the battery is being charged.
• Shows Red and Green (= Yellow): When the unit is switched ON and connected
to a power supply and the battery is being charged
• Shows Red: When the unit Is switched ON and connected to a power supply
and the battery is fully charged.
7. Stereo Output MAlN OUT (3.5mm jack) to connect the input of an ampli er or
another unit, e. g. a second mixer.
8. POWER switch
9. Output MONITOR/ PHONES (3.5mm jack) to connect stereo headphones
(minimum impadance160)
10. Volume Control MONITOR/PHONES for the headphone output MONITOR/
PHONES (9)
11. Button TAPE IN ASSIGN TO MAlN to assign the input signal of the jacks TAPE
IN (3) to the outputs MAIN OUT (7), TAPE OUT (4) and USB (5)
12. Button TAPE IN ASSIGN TO MONITOR to assign the input signal of the jacks
TAPE IN (3) instead of the mixed signal to the headphone output MONITOR/
PHONES (9)
13. Overload LEDs CLIP for the stereo output signal adjusted with the control
MASTER (14)
14. MASTER ControI to set tha level of the output signal sent via the outputs
MAIN OUT (7), TAPE OUT (4) and the USB port (5)
15. Control GAIN for Channel CH 1 to set the input ampli cation.
16. High Frequency Control HI and Low frequency control LO for channel CH 1
17. Control LEVEL for channel CH 1
18. Panorama Control PAN for channel CH 1 to place the mono signal on the
stereo base.
19. Level Peak LED PK for Channel CH 1: if at all, should only brie y light up
with level peaks
20. High Frequency Control HI and Low frequency control LO for channel CH 2/3
21. Control LEVEL for channel CH 2/3
22. Stereo Balance Control BAL for channel CH 2/3
23. Button USB ASSIGN TO CH 2/3 to assign the input signal of the USB port (5)
to channel CH 2/3.
3
www.PyleUSA.com
Advertisement
