Before The First Use - BORETTI B510 Instruction Booklet

« PARTS
1. Spout
2. Button to open the lid
3. Lid
4. Handle
5. Water level indication
6. Base with control panel
7. Heat retention function
8. Cooking at 60 °C
9. Cooking at 70 °C
10. Cooking at 80 °C
11. Cooking at 90 °C
12. Cooking at 100 °C
13. Cord storage in the
bottom of the base
14. Removable filter
« BEFORE THE FIRST USE
Boil a full water kettle twice and pour away the water before actually using the water kettle
for the first time.
« USE
1. Remove the water kettle from its base and open the lid by pressing the top button.
2. Fill the water kettle with the desired amount of water. Make sure that the water level
is always higher than the minimum indication (0.3 l) and lower than the maximum
indication (1.7 l).
▪ If you have not added enough water, the water kettle will switch off before the water
boils.
▪
If you have added too much water, the boiling water could escape through the spout.
That is why you should never exceed the maximum indication when filling the kettle.
Also, always make sure that the lid is properly closed before turning on the watter
kettle.
3. Place the water kettle on its base.
4. Plug in the appliance. The LED light goes on. If you do not select a temperature, the
device will turn off after 5 minutes.
5. Select the desired temperature: 60 °C, 70 °C, 80 °C, 90 °C, 100 °C. The light of the
temperature will begin to flash until the desired temperature is reached.
3
1
5
6
7
8
2
14
4
13
9 10
12
11
29
EN