Operation; Select Tv Channels, Computer Or Other External A/V Sources; Adjust The Volume - Philips 33PX8001/05 User Manual

To be operational with the remote control your TV should be in the TV operation position.
If this is not the case, first press the TV key left of the display. The letters TV in the display of the
remote control appear in a black block for a few seconds.
Every time you press a key on the remote control, a green lamp on the front of your TV set blinks.
TV
VCR 1 TUNER
VCR 2 TAPE
a
SAT DCC
AMP CD
M
B
TV
OK
MENU
B
B
K K
a
0
L L
c
1 2 3
E
e
4 5 6
7 8 9
c
2
J 0
a
c Sound Muted

Operation

Switch TV on
4
A on the front of your TV.
Press
5
A green lamp lights up and the programme appears.
5
Does a red lamp light up ? Your TV is on standby. Read on.
4
Press the red standby key B at the top of the remote control to switch the
TV on.
After the set has been switched off with the mains, it comes up again in the last
status.
Switch to standby
4
Press the red standby key
TV off temporarily.
5
A red lamp on the TV lights up.
4
Press the red standby key B for 2 seconds or P - or + in order to switch the
TV on again.
Your TV consumes energy in the standby mode. Energy consumption contributes to air
and water pollution. We advise to switch off your TV overnight instead of leaving it on
standby. You save energy.
Select TV channels
4
Select the TV channel with the digit keys or with the key P - or + on the
remote control or with the - or + keys on the front of the TV.
4
For a two digit programme number, enter the second digit within 2 seconds.
Quickly run through the TV channels from the Favourite list.
4
Press the P - or + key repeatedly.
Select your computer or external A/V sources
4
Switch on your computer or external A/V sources.
4
a key repeatedly on the remote control until the source
Press the
,
FRONT, A/V 1 A/V 2
4
In case of valid S/VGA signals, the information from your computer appears on
the screen.
If it is necessary to optimize the position of the picture, see Main Menu, Picture
settings, p. 14.

Adjust the volume

4
a - or +.
Press
If you want to store the volume adjustment in the memory, see the Features
menu, General PP Store, p. 18, to store the same volume adjustment for all the
stored TV channels.
When the lowest of the highest possible volume adjustment is not according to your
opinion, the volume limits can be adjusted with the Dealer Service Tool (DST)
(RC7150). (See Special Features for Professional use, p. 34.)
Temporarily interrupt the sound
4
c .
Press
5
The sound is temporarily interrupted.
4
c again to get the sound back.
Press
B at the top of the remote control to switch the
, or is selected.
A/V 3 A/V 4
,
S/VGA
13