To Select Connected Equipment; Cinema Link Surround Receiver; Recorder Or Dvd With Easylink - Philips 28PW9308/05 User Manual

Stereo amplifier and two extra

To select connected equipment

Press the v key on the remote control repeatedly to select
where you connected your equipment at the back or the right side of your TV.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.

Cinema Link surround receiver

See the separate supplied Cinema Link instruction manual.
Attention: the sound info on screen will not correspond with the actual sound reproduction.

Recorder or DVD with EasyLink

The recorder (VCR or DVD+RW) or DVD can
be operated with the remote control via the
or
Recorder
DVD
Recorder
Ò
Rwd Play
DVD
Ò p
Prev. Play
AUDIO
menu on screen.
p ‡ π †
Stop Play Ffw
‡ π †
Stop Play Next Eject
speakers
FRONT
&
Connect the audio cables to the audio input of
your amplifier and to
back of your TV.
é The output level is controlled by the volume
control of the amplifier.
Note: Switch off the TV and your audio amplifier
before connecting them. Set the audio amplifier's
volume to minimum.
& Press the
control.
é
Select the
cursor up/down.
" Press the cursor left/right, up/down to select
one of the recorder or DVD functions.
®
Ï
Rec Eject
The key ® for recording can be operated in the TV
mode.
If your EasyLink recorder has the system standby
Ï
function, when you press the B key for 3 seconds,
both TV and the recorder are switched to standby.
AUDIO L
, or
EXT1 EXT2 SIDE
Ï key on the remote
MENU
or
Recorder
DVD
and at the
R
according to
menu with the
15