Tips - Philips 30PF9975/12 User Manual

Tips

Tips
Care of the screen
Poor Picture
No Picture
Digital distortion
No sound
No solution found
for your picture or TV yourself. Check with your dealer or call a TV technician.
sound problem ?
Menu
TV
NEX IEW
Remote control
Standby
No stable or not
synchronised VGA
picture
Miscellaneous
22
Do not rub or strike the screen with anything hard as this may scratch, mar, or
damage the screen permanently.
Unplug the set before cleaning the screen. dust the TV by wiping the screen and
the cabinet with a soft, clean cloth. If the screen requires additional cleaning, use
a clean, damp cloth; do not use liquid cleaners or aerosol cleaners.
• Have you selected the correct TV system in the manual installation menu?
• Is your TV or house aerial located too close to loudspeakers, non-earthed audio
equipment or neon lights, etc.?
• Mountains or high buildings can cause double pictures or ghost images.
Sometimes you can improve the picture quality by changing the direction of the
aerial.
• Is the picture or teletext unrecognisable? Check if you have entered the correct
frequency. See Installation, Manual installation, p. 6.
• Are brightness, sharpness and contrast out of adjustment? Select Factory settings in
the Setup, General menu, p. 8.
• Are the supplied cables connected properly ? (The aerial cable to the TV, the
other aerial to your recorder, the VGA cables to the display, the power cables.)
• Has the child lock been switched off ?
• Is your PC switched on ?
• Do you see a black screen and the indicator in front of the TV lights up green,
this means that the display mode is not supported. Switch your VGA-source to a
correct mode.
• In case of weak or bad signal, consult your dealer.
The low quality of some digital picture material may be the cause of digital image
distortion. In this case select the Soft setting using the Picture menu, Smart Picture,
without changing the picture settings manually.
• No sound on any channel? Check the volume isn't at minimum.
• Is the sound interrupted with the mute key
Switch your TV off and then on again once. Never attempt to repair a defective
Have you selected the wrong menu? Press the menu key again to exit from the
menu.
Orange indicator on front of the TV during standby / No
See Acquisition and updating of
Displayed time is wrong:
The broadcaster on programme number one does not transmit the correct local
date and time. Use Reshuffle in the installation menu to place another broadcaster
on programme number one.
• Check if the remote control is in the correct mode.
• If your TV no longer responds to the remote control, the batteries may be dead.
• You can still use the
Your TV consumes energy in the standby mode. Energy consumption contributes
to air and water pollution. Power consumption: 2 W.
Check if you have selected the correct VGA mode in your PC. See the separate
instruction manual with the monitor.
. Ambient temperature: + 5~ + 35°C
. Mains: 50/60 Hz Auto Voltage ranging from 198 V to 264 V
. Power consumption: around 170 W
. Standby consumption: 1 W
. Weight (excl. packaging): 17 kg
. Dimensions (wxhxd): 891x489x110
TV information, p. 14.
NEX IEW
key and the -/+ keys on top of your TV.
MENU/OK
¬
?
NEX
TV info:
IEW