Front Connections; Multi Channel Surround Receiver; To Select Connected Equipment - Philips 30PF9975/12 User Manual

Front connections

S•VIDEO VIDEO AUDIO
L R
L
1 2 3

Multi channel Surround receiver

CENTRE IN
AUDIO
S•VIDEO
VIDEO AUDIO
L
L R
R
OUT
1

To select connected equipment

Press the v key on the remote control repeatedly, or select Source in the Setup menu (see p. 9) to
select , ,
EXT1 EXT2 EXT3
equipment.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
18
Camera or Camcorder
&
Connect your camera or camcorder as shown.
é
Connect to
equipment. For stereo equipment also connect
ANTENNA
75
SERVICE
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the
audio inputs 3.
Do not connect cable 1 and 2 at the same time. This may cause
picture distortion !
Headphone
Insert the plug into the headphone socket L as shown.
&
Press ¬ on the remote control to switch off the internal
é
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm. The
headphone socket has a 3.5 mm jack.
In the Sound menu select
headphone volume.
& Connect the audio cable to the multi channel Surround receiver
and to
é
If you want the loudspeakers of your TV to act as centre
speaker, also connect an audiocable to the multi channel
Surround receiver and to the
your TV 2.
2
"
Select
The loudspeakers of the TV will now only produce centre
sound, the loudspeakers connected to the audio receiver will
produce Surround Sound.The volume has to be controlled via
the multi channel Surround receiver.
Note: No sound will be heard when a TV channel or external source is
blocked via the Child lock menu (see p. 12).
, , ,
EXT4 YPbPr FRONT
2 and
VIDEO
Headphone volume
and
AUDIO OUT L
in the Source menu. See p. 9.
Centre Input On
or according to where you connected your
VGA
3 for mono
AUDIO L
AUDIO R
input 1 and
S-VIDEO
to adjust the
at the bottom of your TV 1.
R
at the bottom of
CENTRE IN
3.