Subscribe to Our Youtube Channel
Related Manuals for OPTICLIMATE 4000 PRO5
Summary of Contents for OPTICLIMATE 4000 PRO5
- Page 1 Water Sourced Heat Pump (Horizontal type ) TopclimTopclimate water sourced heat pump Manual ate water sourced heat pu MODELS: 4000 PRO5 ~ 15000 PRO5 CAPACITIES: 4KW~15KW...
-
Page 2: Table Of Contents
OptiClimate Water Sourced Heat Pump Index 1 Production Introduction......................2 1.1 Specification................................2 1.2 Dimension..................................3 2 Information of Controller......................5 2.1 General Logic................................5 2.2 Control panel................................5 2.3 Control Operations..............................6 2.4 Function descriptions...............................7 2.5 System protections and error code........................8 3 Installation............................8 4 Commissioning..........................9... -
Page 3: Production Introduction
OptiClimate Water Sourced Heat Pump 1 Production Introduction 1.1 Specification Item Model 4000 PRO5 6000 PRO5 10500 PRO5 15000 PRO5 Cooling capacity 10.5 Rated input power Electrical Heater 1×1.5 2×1.5 2×2.0 2×2.0 Power Supply 220V/50Hz/1Ph Type Rotary Rotary Scroll Scroll... -
Page 4: Dimension
OptiClimate Water Sourced Heat Pump 1.2 Dimension 1、4000 PRO5 （Packing size L×W×H: 1080×646×588） （Packing size L×W×H: 1130×646×618） PRO5 2、6000 http://www.hicoolopticlimate.com/... - Page 5 OptiClimate Water Sourced Heat Pump 3、10000 PRO5 （Packing size L×W×H: 1250×746×668） 4、15000 PRO5 （Packing Size L×W×H: 1250×746×668） http://www.hicoolopticlimate.com/...
-
Page 6: Information Of Controller
OptiClimate Water Sourced Heat Pump 2 Information of Controller 2.1 General Logic The basic control logic is, making cooling in day time, making auto cooling ， heating and dehumidification in night time, through the sensor. 2.2 Control panel The panel of wired controller is as follows 2.3 Control Operations. -
Page 7: Function Descriptions
OptiClimate Water Sourced Heat Pump □ Press < — > < > key to adjust needed hour. □ Press <△> key, then the minute area flashes. □ Press < — > < > key to adjust needed minute. □ Press SET key again to finish setting. -
Page 8: System Protections And Error Code
OptiClimate Water Sourced Heat Pump 3. Compressor starts with delay after external water valve starts. After external water valve works for 9 seconds, system starts compressor after making sure the circulating water fills the heat exchanger. 4. Loading and unloading with time delay. -
Page 9: Installation
OptiClimate Water Sourced Heat Pump Error Reasons of Error Conditions Protection Recovering condition code External flow switch EE：01 Flow switch opens for 10 s Stop unit Repair opens After 30 minutes of compressor operation during cooling, the indoor 1#Compressor EE：03... -
Page 10: Commissioning
OptiClimate Water Sourced Heat Pump b). Transit Hoist, sling or forklift is suggested for transit. Please pay attention to protect the unit during transit, and keep the units horizontal during the transit to avoid damage to compressor system. 2). Installation The units can be installed freely onto the ceiling, in toilet, in any room, in stair well or at outdoor. -
Page 11: Maintenance
OptiClimate Water Sourced Heat Pump direction of motor, the noise of system and duct, etc. Please pay attention to following points during commissioning. a. Indoor temp setting of controller should be reasonable, not too high or too low. b. Please keep the indoor controller away from computer, TV, and other home appliances, to avoid signal jam between different control systems. -
Page 12: Appendix
OptiClimate Water Sourced Heat Pump 6 Appendix Wiring Diagram http://www.hicoolopticlimate.com/... - Page 13 OptiClimate Water Sourced Heat Pump http://www.hicoolopticlimate.com/...
Need help?
Do you have a question about the 4000 PRO5 and is the answer not in the manual?
Questions and answers