Active Controls ErgoRejoy Installation Instructions

Modular ERGOnomic REpositioning
JOYstick Platform Installation Instructions
The ErgoReJoy assessment kits are shipped in a custom box with each component labeled with part
numbers to facilitate installation. We recommend storing the 5" and 8" adjustable arms; double
ball adaptor; and JoyPad™ with 3" extension arm in the sample case until required for use during
the assessment.
I. Install socket brackets (30380) (with pre-installed sockets 30200) to PWC armrest using
the Stealth universal round tube mounting brackets (refer to figure A). f the PWC's
armrests do not have mounting slots for the brackets' nuts, then it may be necessary to drill
and tap holes in the armrests' pads brackets (refer to figure
figure 1a
not compatible with the PWC armrests, please call - 00-
. nsert mini mast ( 0
the mini-mast to make sure it is fully inserted (refer to figure b).
. nstall PWC joystick to ErgoReJoy platform (
photograph a side view in its standard armrest position.
A. Remove joystick harness from controller joystick port located on the PWC base noting
its location
figure 1B
. Remove joystick and joystick mounting bracket from PWC.
C. R et joysticks have two different joystick cable configurations
D. nstall R et joysticks with fixed harnesses and
holes which are -
figure 2a
platform (
E. nstall R et joysticks with removable harness in
the two rear holes which are
(see figure )
F. nstall - ogic , or , E , Shark joysticks
with two M- screws using the holes which are
figure 2B
) in socket ( 0 00) (refer to figure a). Press down on the top of
. f the R et joystick has a removable harness, install the Active Controls joystick
harness ( 0 ) in place of the original harness
a. Route the 0 cable through the long slot of the ErgoReJoy platform (
. f the R et joystick has a fixed harness, route the harness through the long slot of the
joystick platform ( 00)
R joysticks with M- screws in the front two
" apart (see figure ) to
00)
- " apart (refer to figure )
). f the Stealth brackets are
-
00). efore removing joystick from PWC,
" apart
ext .
00)