Advertisement
Select Desired Spikes
Depending on the desired mounting height and condition of the
surface on which this speaker unit is to be installed, the spike
feet used with this unit can be selected from those provided
with the unit. Consult the accompanying chart when selecting
the spike feet you wish to use.
Spikes
Installation location
Cone-shaped
Locations with thick
spikes (a)
carpet, floors where
no marks will be
caused or scars do
not matter.
28 mm
(1.1 in.)
Cone-shaped
Flat surface
spikes (b)
19 mm
(0.7 in.)
Flat surface
Use no spikes
Using the spikes
The speaker stands include spikes that you can use to isolate
the speaker from the floor. Spikes are recommended when
placing the stand on a thick carpet (for added stability), or for
better sound when placing the stand on a hard reverberant
surface (such as a concrete or wood floor). Use the supplied
spike bases to avoid scratching the floor or other surface where
the stand is placed.
When attaching the three spike feet to the unit, always use
the same kind of feet.
1 Screw the spikes into the three locations indicated on
the bottom of the stand base.
2 Adjust the length of the auxiliary support feet as
required to correct any uneven floor contact, then tighten
using the hex nuts.
Stand base
Application
Press spikes into carpet.
Carpet
Sub-floor
In order to prevent marks
on the floor, use the spike
bases provided.
Apply the non-slip cork
pads to the three locations
indicated in the illustration.
Stand base
Non-slip cork pads
When using cone-shaped spikes (b)
Place the spike bases in the location where the spikes are to
rest, then place the speaker stand on top of the spike bases.
Note that these spikes are sharp metal and can cause
damage to flooring. Make sure to lay down a cloth or
suitable base before setting up.
The spike bases should be placed as shown below (with
the depression on the top side).
Make sure to use the spike bases provided to avoid
damaging the surface where you place the stand.
Attaching speakers TAD-ME1 to the stands
To avoid accident or injury, please use screws to secure the
speakers to the speaker stands.
1 Secure the speaker to the speaker support plate using
the screws (Bind head with washer) as shown below.
Nuts for securing the speaker to the speaker support plate
are embedded in the bottom surface of the speaker.
Speaker support
plate
Do not attempt to fasten this speaker stand to any object
other than the TAD-ME1 speaker system for which it was
designed, since uneven balance may cause the object to fall,
resulting in personal injury.
TAD-ME1
Fastening nuts
Screw holes
for securing
speaker
(2 positions)
Screws
(Bind head with
washer)
(3-939030-034035)
3
En
Advertisement
