Advertisement
Thank you for buying this TAD product. The TAD-ST3 is a
speaker stand exclusively designed for use with the TAD-ME1
speaker system.
Please read through these operating instructions for proper
assembly and use. After you have finished reading the
instructions, put them away in a safe place for future reference.
Before you start
Before setting up your speaker system, we recommend reading
the operating instructions for your system thoroughly.
Only use the screws supplied when fixing the speaker to
the speaker stand.
Do not place the stand on an unstable and/or sloping
surface. The stand and speaker may fall and cause injury.
Do not attempt to use this stand to support any object
other than the TAD-ME1 speaker system for which it was
designed. The stand may collapse and be damaged and/or
the speaker may fall and cause injury.
When moving the speaker and stand, first remove the
speaker from the stand, and then move the stand, holding
it by the stem.
Installing the speaker stands
Place the stand on a stable, level surface; placing the stand on
an unstable surface can be dangerous.
TA D a s s u m e s n o l i a b i l i t y w h a t s o e v e r f o r d a m a g e s
resulting from assembly, improper mounting, insufficient
reinforcement, misuse of the product, acts of nature, etc.
On the rear strut of this product, 3 angles have been installed
to bundle the speaker cables. For bundling up the speaker
cables, use a commercially available cable bundling product
and bind the cables as shown in the illustration.
Cable tie
2
En
Assembling the speaker stands
Assemble the speaker stands as illustrated below. Please note
that a Phillips screwdriver will be necessary for assembly. The
following illustration shows the fully assembled speaker stand:
Speaker support
plate
Stand stem
Stand base
Align the screw holes on the stand base and speaker
support plate with the screw holes in the stem, then insert
the screws and tighten.
Speaker support plate
Stand stem
Stand base
Screws
(Bind head with washer)
(3-939030-034034)
* The illustration here depicts the speaker stand when equipped
with cone-shaped spikes (type b).
Make sure you assemble the stand on a flat surface that is
relatively soft (such as a carpet).
Screw holes
for securing
speaker
(2 positions)
Screws
(Flat head, M6 x L=25)
(3-939030-034036)
*Dowel side is for
Stand base
Cone-shaped spikes (b)
(3-939009-030271)
Auxiliary support feet
with hex nuts
(3-939009-030273)
Advertisement
