Silhouette DIM32D1BSSPR Owner's Manual page 6

INSTALLATION INSTRUCTIONS
WATER INLET HOSE INSTALLATION
WARNING
To avoid electrical shock, which can cause death
or severe injury, ensure the ice maker is not
plugged in before connecting the water supply
line.
Plastic tubing is not recommended for the inlet hose
as it greatly increases the potential for water leaks.
The manufacturer will not be responsible for any
damage if plastic tubing is used for the water supply
line.
Do not install water supply tubing in areas where
temperatures fall below freezing.
Ensure the ice maker is connected to a potable
water source that is not tied into a water softening
system. Chemicals from the water softener may
damage the ice maker.
Ensure that the water supply line complies with all
local plumbing codes.
Required Tools
• Adjustable wrench
• Flat blade screwdriver
• A household cold water line with water pressure
between 20 and 60 psi.
• A water supply hose made of 1/4 inch (6.4
mm) OD copper tubing. To determine the length
of copper tubing needed, measure the distance
from the ice maker inlet valve at the back of the
appliance to the cold water supply, then add
approximately 3 feet (0.9 meters) so that the
ice maker can be moved out of the cabinet for
cleaning.
• A shut off valve to connect the water supply line
to the household water system. Do not use a self-
piercing type of shut off valve.
• A compression nut and ferrule (sleeve) for
connecting the water supply line to the ice maker
inlet valve.
• A clamp and a number 8, 1/2" screw to secure
the water line.
Connecting the Water Supply
1. Ensure the ice maker is disconnected from the
power supply.
2. Place the end of the house water supply line into
a sink or bucket. Turn on the water supply and
fl ush the supply line until the water is clear. Turn
off the water supply at the shut off valve.
3. Remove the plastic cap from the water inlet valve
on the back of the ice maker.
4. Slide the brass compression nut and the ferrule
(sleeve) onto the water supply line.
5. Push the water supply line into the water valve
inlet as far as it will go, approximately 1/4".
Slide the ferrule (sleeve) into the water valve
inlet and tighten compression nut onto the valve.
Tighten another half turn with a wrench. Do not
over tighten.
6. Secure the water line to the back of the
appliance using the clamp and screw.
7. Coil approximately 3 feet of water supply line
behind the ice maker and arrange the coils so
that they do not vibrate or wear against any
surface.
8. Turn on the water supply at the shut off valve
and tighten any connections that leak.
5