Advertisement
Available languages
Available languages
Thank you for purchasing this Price Pfi ster bathroom faucet. All Price Pfi ster products are carefully engineered, and factory tested to provide
long trouble-free use under normal conditions. This bathroom faucet is easy to install using basic tools and our easy to follow illustrated
instructions. If you have any questions regarding your bathroom faucet installation call 1-800-Pfaucet (1-800-732-8238)
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding.
Price Pfi ster recommends calling a professional if you are uncertain about
installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are
usually found under the sink or near the water meter. If you are replacing an
existing faucet, remove the faucet from the sink and clean the sink surface
thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant
• Slotted screwdriver
• Phillips head screwdriver
• Adjustable wrench
• Flashlight
Your installation may require new supply lines and/or shut-off valves or other
additional tools.
This product comes with a Hex Wrench for tightening the spout.
INSTALLATION STEPS
4
4C
4 SPOUT ATTACHMENT
(Model Georgetown 49-B is shown) Depending on model, either place Plastic
Seal Ring or Protective Washer (4A) against the top of Center Hole (4B). For
Carmel and Georgetown models, place Spout Base Ring (4C) onto countertop.
Rotate Retainer Bracket (4D) to a vertical position as shown. Insert Spout Shank
(4E) through the Center Hole of sink.
• Plumber's putty
• Pliers
• Cloth
4D
4E
4A
4B
ENGLISH
5
5C
5. SECURING SPOUT
From above, insert Hex Wrench (5A) into pop-up hole in Spout (5B). Turn Hex
Wrench (5A) clockwise to tighten. Before fi nal tightening, be sure Spout (5C)
is centered and facing forward.
6
6D
6C
6
VALVE BODY INSTALLATION
Rotate Retainer Bracket (6A) to a vertical position. Insert Valve Body (6B)
through Mounting Holes (6C) on the top of fi xture. The HOT valve, labeled with
Red Tag (6D), should be positioned to the left side of the Spout (6E).
3
.
5B
5A
6A
6B
6E
6C
Advertisement
