Basic Antenna Connection; Basic Cable Tv Connection - Philips 20PT653R Directions For Use Manual

A
combination antenna receives normal
broadcast channels (VHF 2–13 and
UHF 14–69). Your connection is easy
because there is only one 75Ω (ohm)
antenna plug on the back of your TV, and
that's where the antenna goes.
1
If your antenna has a round cable
(75 ohm) on the end, then you're ready
to connect it to the TV.
If your antenna has flat, twin-lead
wire (300 ohm), you first need to
attach the antenna wires to the screws
on a 300- to 75-ohm adapter.
2
Push the round end of the adapter (or
antenna) onto the 75Ω (ohm) plug on
the back of the TV. If the round end of
the antenna wire is threaded, screw it
down finger tight.
c c C
I
HECK
Use the AutoProgram Control to add all avail-
able channels into the TV's memory, then
press the CH + and – buttons to scroll the
channels.
Y
our Cable TV input into your home may
be a single (75 ohm) cable. If so, this con-
nection is very simple. Follow the steps below
to connect your cable signal to your new tele-
vision.
Direct Cable Connections:
1
Connect the open end of the round
Cable Company supplied cable to the
75Ω input on the TV. Screw it down fin-
ger tight.
c c C
I
HECK
Use the AutoProgram Control to add all avail-
able channels into the TV's memory, then
press the CH + and – buttons to scroll the
channels.
B A
ASIC NTENNA
Antenna Connection:
O
T UT
B C
ASIC ABLE
Direct Cable Connection:
Cable signal coming
from Cable
Company (Round
75Ω coaxial cable)
O
T UT
T C
ELEVISION ONNECTION
Outdoor or Indoor Antenna
(Combination VHF/UHF)
The combination antenna receives normal
broadcast channels 2-13 (VHF) and 14-69 (UHF).
1
Twin
Lead Wire
Round 75Ω
Coaxial Cable
from Antenna
T C
ELEVISION ONNECTION
1
7
300 to 75-ohm
Adapter
2
Jack Panel
Back of TV
BACK OF TV
ANT 75‰ Monitor out AV1 in AV2 in
VIDEO
L/Mono Y
Pb
AUDIO
S-VIDEO
R Pr
COMPONENT VIDEO INPUT
Jack Panel Back of TV
ANT 75‰ Monitor out AV1 in AV2 in
VIDEO
L/Mono Y
Pb
AUDIO
S-VIDEO
R Pr
COMPONENT VIDEO INPUT
Back of TV