How To Order - Bulldog Security DC Series Owner's Manual

• Check the winch rope. Before winching, make sure the rope is
wound on the drum evenly. If there is mixed winding, it is essential
to rewind it evenly. Figure 14.
• Be careful to keep the rope under tension. Never guide a wire rope
onto the drum with your hand, use a hand saver cable strap or
wear leather gloves.
3.2 Lubrication
All moving parts in the winch are permanently lubricated at the time of assembly. Under normal condi-
tions factory lubrication will suffice. If re-lubrication of gear box is necessary after repair or disassem-
bly use Shell EP2 or equivalent grease. Never lubricate the brake system.
3.3 How To Order Replacement Parts
Use only Horizon Global parts or parts of equal quality for repair. Replacement parts are available
through Horizon Global's Tech Service Department, 1-800-632-3290. Please specify product model
number.
Read, understand and follow the warnings
and instructions in this manual.
Check all fasteners and verify they are at the
proper torque.
Replace fasteners as needed.
Check that the wiring is correct and the
connections are tight
Check that there are no bare or exposed
wires, terminals, or damage to the cables.
Cover terminals with boots. Repair or
replace wires as needed.
If damaged, discontinue use and replace
rope immediately.
Keep winch, rope, and switch control free
from contaminants.
Use a clean rag or towel to remove any dirt
and debris.
14
Maintenance
Checklist
Table 6 - Checklist
HORIZON GLOBAL •
Before
First
Operation
X
X
X
X
X
F4106-00 REV A (9528) 11/17
Figure 14 - Mixed Winding
After
Every
EVERY
90 Days
Use
X
X
X
X X
X