Connect Peripheral Equipment; Connecting And Selecting Equipment; Side Connections - Philips 29PT9417/12 User Manual

Connect Peripheral Equipment

There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Note: can handle CVBS and RGB,
EXT. 1
peripherals with RGB output to
If your recorder is provided with the Easylink function, it should be connected to
functionality.
Recorder
( -
VCR DVD
CABLE
2
EXT.
1
2
4
Other equipment
CABLE
1
4
2

Side connections

1 2 3
18
EXT. 2
or
EXT. 1 EXT. 3
+ )
RW
Connect the aerial cables 1,
picture quality, eurocable 3 as shown.
If your recorder does not have a euroconnector, the only possible
connection is via the aerial cable.You will therefore need to tune in
your recorder's test signal and assign it programme number 0 or
store the test signal under a programme number between 90 and
99, see Manual installation, p. 6.
See the handbook of your recorder.
Decoder and Recorder
Connect a eurocable 4 to your decoder and to the special
euroconnector of your recorder. See also the recorder handbook.
See Decoder, p. 9 You can also connect your decoder directly to
EXT. 1
(satellite receiver, decoder, DVD, games, etc.)
Connect the aerial cables 1, 2 and 3 as shown (only if
&
your peripheral has TV aerial in-/output).
Connect your equipment with a eurocable 4 or 5 to one of
the euroconnectors
1
EXT.
quality.
2
é
Look for the test signal of your peripheral in the same way as
you do for a recorder.
3 5
"
Make a selection in the Setup, Source menu, p. 9.
Camera or Camcorder
&
Connect your camera or camcorder as shown.
é Connect to
equipment. For stereo equipment also connect
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the S-video input 1 and
AUDIO
Do not connect cable 1 and 2 at the same time. This may cause
picture distortion !
Headphone
Insert the plug into the headphone socket L as shown.
&
Press ¬ on the remote control to switch off the internal
é
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm.
The headphone socket has a 3.5 mm jack.
In the Sound menu select
headphone volume.
CVBS and Y/C,
EXT. 3
as RGB provides a better picture quality.
or with a eurocable.
2
EXT.1
2 and
VIDEO
inputs 3.
CVBS and RGB. It is preferred to connect
to benefit from the EasyLink
EXT. 2
2 and, to obtain the optimum
, or to obtain a better picture
2 3
3 for mono
AUDIO L
Headphone volume
3.
AUDIO R
to adjust the