Using The Self-Propel Drive; Shutting Off The Engine; Recycling The Clippings - Toro 20836 Operator's Manual

Figure 16
Note:
If the machine does not start after several
attempts, contact an Authorized Service Dealer.

Using the Self-Propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the machine will automatically keep pace
with you (Figure 17).
Figure 17
Note:
If the machine does not freely roll backward
after self-propelling, stop walking, hold your hands
in place, and allow the machine to roll a couple of
centimeters (inches) forward to disengage the wheel
drive. You can also try reaching just under the upper
handle to the metal handle and pushing the machine
forward a couple of centimeters (inches). If the
machine still does not roll backward easily, contact an
Authorized Service Dealer.

Shutting Off the Engine

Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Important:
When you release the blade-control
bar, the engine should shut off and the blade
should stop within 3 seconds. If they do not, stop
using your machine immediately and contact an
Authorized Service Dealer.

Recycling the Clippings

g012133
Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
Note:
The grass bag may remain on the machine
while you are recycling the clippings.
To recycle the clippings, move the bag-on-demand
lever to the R
ECYCLING
g003221
1. R position
ECYCLING
10
position (Figure 18).
Figure 18
2. B position
AGGING
g012135