Advertisement
Quick Links
Advertisement
Related Manuals for SIP 2000
Summary of Contents for SIP 2000
- Page 1 1/12/2011 SIP 2000 programming manual...
- Page 2 Sip 2000 main control unit Bottom view of the SIP 2000 main control unit 1/12/2011 SIP 2000 instructions revised B...
- Page 3 A multi-colored ribbon cable with a led light on one end and a 6-pronged connector on the opposite end has been packed with your unit. The SIP 2000 is protected by a 2 amp fuse located near the left side of the power cord B socket. The fuse is clearly marked “fuse”.
- Page 4 Your SIP system has been pre-programmed at the factory. Only the local time needs to be adjusted to make your SIP system functional. Follow the guide below to adjust the local time settings. If you would like to adjust your SIP 1/12/2011...
- Page 5 SIP 2000 to manufacture ozone. You should program the air pump to continue working for 10 minutes after the ozone function is completed. This allows the ozone to be dissipated and to leave no residual ozone in the reservoir after the program is completed.
- Page 6 Press button to set the minute section to 10 as in the example above. You now have programmed your SIP 2000 unit to turn off the O (Ozone Generator) at 3:10 AM. (Air Pump) Program After the above settings are confirmed, press the button to shift to the setting of the Air Pump operation time.
-
Page 7: Setting The Local Time
SETTING THE LOCAL TIME The last stage in the programming of the SIP system is setting the local time. A time adjustment will most likely be needed to set the clock to your local time. Here is an example of how change the clock from midnight (00:00) to 10:10 PM (22:10). - Page 8 • process installation process quicker. You must connect all the parts to the SIP 2000 box as outlined in page 1. You must them attach the SIP 2000 box • to the bracket using the screws provided, install onto the cooler and follow the installation instructions below.
- Page 9 The check valve stops the possibility of any water moving back through the tubing and into the air filter and the SIP unit itself. In order to fit these parts you need to cut the tubing and re-attach it at either end of the part.
- Page 10 AIRWAYS, DIFFUSER, A IR PUMP (WHERE APPLICABLE), LED LIGHT, TESTING BUTTON, IEC CONNECTIONS AND DOWN ROD. IF A DEFECT ARISES AND A VALID CLAIM IS RECEIVED BY SIP WITHIN THE WARRANTY PERIOD, AT ITS OPTION, SIP WILL (1) REPAIR THE...
Need help?
Do you have a question about the 2000 and is the answer not in the manual?
Questions and answers