Advertisement
4. Plug the power adapter into the wall socket.
5. Connect the power adapter with the HDMI selector.
6. Turn on the monitor first.
7. Turn on the DVD player/TV receiver.
Operation
1. Port selection
Press the button of "port selection switch" for
accessing the wanted DVD player/TV receiver.
The selected corresponding port will light on for the
LEDs which indicating the port is activated.
-2-
2. IR remote control
Use "1" ~"7" key to select video input port.
Use "◄", "►" key to select another video input port.
Use "
" key to power on/off.
Support HDMI mode
Max resolution:
UXGA(1600x1200@60), 1080p@60, 12-bit.
Support VGA mode
Analog
Resolution
VGA
640x480
VGA
720x400
SVGA
800x600
WVGA
848x480
XGA
1024x768
SXGA
1152x864
SXGA
1280x768
WXGA
1280x800
SXGA
1280x960
SXGA
1280x1024
WXGA
1360x768
SXGA+
1400x1050
WXGA+
1440x900
SXGA+
1440x1050
UXGA
1600x1200
WSXGA+
1680x1050
1080p
1920x1080
WUXGA
1920x1200
720p
1280x720
Support YPbPr mode
Analog
480i
576i
480p
576p
720p
1080i
1080p
Support CVBS/ S-Video mode
Analog
480i
576i
Frequency(Hz)
60 / 72 / 75 / 85
70 / 85
56 / 60 / 72 / 75 / 85
60
60 / 70 / 75 / 85
75
60RB/ 60 / 75 / 85
60
60 / 85
60 / 75 / 85
Matrix Application Software
60
60RB / 75
Software Introduction
The 《AV Matrix》 Matrix control software applies to
60
60
different input/output matrixes.
60
Software Activation
60
Power on the computer: Implement the AV Matrix.msi to
60
activate installation screen as below, click "Next". And
60RB
follow the instructions on screen to finish the installation.
60
Resolution
Frequency(Hz)
720x480
60
720x576
50
720x480
60
720x576
50
1280x720
50 / 60
1920x1080
50 / 60
1920x1080
50 / 60
-3-
Resolution
Frequency(Hz)
720x480
60
720x576
50
Connect Multi-Format to HDMI Conversion Box and PC
You must power off the Multi-Format to HDMI Conversion
Box. Then, connect the RS-232 port to the PC's RS-232
port.
Matrix Configuration
After finishing installation, click
AV Matrix Application. In the "Options" screen, select the
connected PC Port number and Baud rate, and then click
"OK".
-4-
Press the "Scan" and found the connected Multi-Format to
HDMI Conversion Box first.
Then use mouse cursor to select which input port to switch,
and press the left button
Communication Protocol/Control Command Code
Communication Protocol: Baud rate 9600bps, no odd or
even calibration bit address, 8bit transmission address,
1bit stop address. Please refer to the "Command list.pdf"
in the CD-ROM for more relative Command Code
information.
to active
Advertisement
