Advertisement
INSTALLING THE MOUNTING ACCESSORY
A. Attach the mount base (
screws (
) and plastic bushings (
3
B. Wind Teflon tape around both threaded ends of the pipe (about 20 times) for sealing. If necessary,
use a silicone rubber sealant to seal the area where the mount base and the pipe meet.
C. Fit the pipe (of which threads are covered by Teflon tape) into the mount base (
is securely fastened.
D. Pull all the required cables through the mount base (
E.
Align the dome adaptor (
F.
Fasten the mount base (
G. Fasten the vandal proof dome housing to the dome adaptor (
How to install the plate
Without Junction Box
2
1
3
Cable
Specifications
1. Cable passing through the wall
Plate
Mount
Base
Cable
3. Cable passing through the
wall with the junction box
(Attention to the plate side)
Rev Date: 02/17
) and plate (
) to the ceiling or wall using the supplied M6 tapping
1
2
).
4
) with the pipe and turn until it is securely fastened.
6
), dome adaptor (
) using the set screw.
1
6
4
2. Cable on the wall (Remove the conduit
knockout for cable passing through)
Plate
Mount
Base
Cable
Knockout
Plate
Mount
Base
Cable
Junction
Box
1
) and pipe (
).
1
5
) using M6 x 12 machine screw.
6
With Junction Box
2
1
Cable
Dimensions (mm)
Mount Base
Quick Start Guide
) and turn until it
Junction Box
Seal around the mount base
tightly using silicon rubber
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
1
5
6
Advertisement
