Bissell PROHEAT 2X LIFT-OFF 66E1 Series User Manual page 22

Operati s
2. Using the brush on the tool, gently scrub
the area to be cleaned.
3. Apply downward pressure on the tool and pull
it toward you. The suction will remove the dirt and
cleaning solution. Continue until no more dirt can
be removed.
Cleaning with Deep Reach™ Tool
1. Set tool on soiled surfaces and press the
trigger to spray solution onto the soiled
area to be cleaned.
2. Slowly move the tool back and forth
over the soiled surface, keeping the tool
in contact with the carpet.
3.Release trigger and move tool slowly over
the soiled area to suction up water and dirt.
4. Continue to clean the area, working in small
sections, until no more dirt can be removed.
Cleaning with the 3-in-1 Stair Tool
This versatile 3-way tool sprays, scrubs, and
suctions up dirt and stains from the outer curves,
corner, and tread of carpet staircase.
1. Twist the tool head to desired setting to clean
carpeted stair. The downward facing edge is the
active cleaning mode.
a. Use the flat area to clean top of stairs
b. Use indented area to clean outer corner
(nose) of stairs
c. Use pointed edge to clean inside crevice
2. Ensure the tool spray tip is pointing
downward. Pressing trigger, slowly move the
tool back and forth over the soiled surface
keeping the tool in contact with the carpet.
3. Release trigger and move tool slowly over the
soiled area to suction up water and dirt.
4. Continue to clean the area until no more dirt
can be removed.
Empty dirty tank
Follow the instructions under Empty dirty
tank section on page 9 of the Upright
cleaning mode section.
1.
3.
a. b.
www.BISSELL.ca
c.
1-800-263-2535
11