Table of Contents
Advertisement
Sound
Before you begin:
You must set Home in Location.
Otherwise, personalized picture and sound settings will not be
memorized after the unit goes into Standby mode.
1
Press MENU / EXIT and use ▲▼ to select Sound, then press OK.
Picture
Auto sound
Sound
Equalizer
Setup
SRS TruSurround HD
Features
Auto volume leveling
Language
TV speakers
USB
Audio Setting
2
Use ▲▼◄► to select the item you want to adjust, then press
OK.
to select the desired setting, then press OK.
(Personal, Standard, Vivid, Sports, Movie, Music and
News)
Auto sound
When you adjust the following settings (Equalizer,
SRS TruSurround HD and Auto volume leveling),
Personal will be set automatically.
Adjust the tonal quality for each frequency.
Cursor ◄
Equalizer
to adjust the each level of tonal quality
Press BACK to go back to the previous menu.
This selects sound modes for more spatial or surround sound
reproduction.
Off
SRS TruSurround HD
On
This function keeps a constant loudness differential between the TV
commercials and the programs.
Off
Auto volume
leveling
On
You can select the Audio Output from the unit's speakers or not. If your
amplifi er is HDMI link function compatible and connected by an HDMI
cable to this unit, some sound operations such as volume up can be
changed by using this unit's remote control. Make sure Master EasyLink
is set to On.
p. 26
➠
On
Off
TV speakers
Speakers
EasyLink
You can set the output mode as a default for the sound mode (Analog TV only).
This setting is not interlocked when you change the output mode by
pressing SAP. Refer to Switching audio mode.
Stereo
Audio Setting
Mono
SAP
p. 27
➠
Standard
On
Off
On
Stereo
Cursor ►
to set SRS TruSurround HD™ to Off
to set SRS TruSurround HD™ to On
to remove the auto volume leveling
to reduce volume differences between
the TV commercials and the programs
to output sound from the unit's
speakers
not to output sound from the unit's
speakers
to control Audio Output from your
connected EasyLink Compliant Devices
with VOL + / − by using this unit's
remote control.
p. 16
➠
to output stereo-audio
to output mono-audio
to output second audio program
Setup
Before you begin:
Make sure the unit is connected to antenna or cable.
1
Press MENU / EXIT and use ▲▼ to select Setup, then press OK.
Picture
Autoprogram
Sound
Channel list
Setup
Add channels
Features
Antenna
Language
USB
2
Adjust the following items.
Autoprogram
Be sure the RF cable is correctly connected to this unit and you are
registered with your cable TV provider when you install Cable channels.
1
Use ▲▼ to select Autoprogram, then press OK.
• If you run Autoprogram when you have locked channels, a
message appears asking to enter your PIN . Enter your PIN in
order to complete the installation. You need to set the channel
lock again after the installation.
2
Use ▲▼ to select an appropriate option, then press OK.
– When Antenna is selected, the TV detects antenna signals.
It searches for DTV and Analog TV channels available in your
area.
– When Cable is selected, the TV detects signals supplied by cable. It
searches for DTV, Analog TV and Cable channels available in your
area.
Picture
Autoprogram will rescan all channels.
Auto programming may take more than 20
Sound
minutes to complete.
Setup
Features
Select your signal source.
Language
Antenna
USB
Cable
Back
Antenna
Cable
Or
ANTENNA IN
Continued on next page.
20
English
Advertisement
Table of Contents
