Use Philips EasyLink
Get the most out of your HDMI-Consumer
Electronic Control (CEC) compliant devices
with Philips EasyLink enhanced control features.
If your HDMI-CEC compliant devices are
connected through HDMI, you can control
them at the same time with your TV remote
control.
To enable Philips EasyLink, you need to:
•
Connect at least two HDMI-CEC
compliant devices through HDMI
•
Configure each HDMI-CEC compliant
device properly
•
Switch on EasyLink
Note
•
The EasyLink-compliant device must be
switched on and selected as the source.
•
Philips does not guarantee 100%
interoperability with all HDMI CEC devices.
Switch on or off EasyLink
When you play an HDMI-CEC compliant
device, the TV switches on from standby, and
switches to the correct source.
Note
•
If you do not intend to use Philips EasyLink,
switch it off.
1
Press .
2
Select [Setup] > [TV settings] >
[EasyLink] > [EasyLink].
3
Select [On] or [Off], then press OK.
Use one-touch play
1
After you switch on EasyLink, press play
on your device.
» The TV automatically switches to the
correct source.
Use one-touch standby
1
When you press
control, the TV and all HDMI-CEC
compliant devices switch to standby
mode.
» The TV and all connected HDMI
devices switch to standby.
Use a Kensington lock
There is a Kensington security slot at the back
of the TV. Prevent theft by looping a Kensington
lock between the slot and a permanent object,
such as a heavy table.
on the TV remote
EN
23