1. Manuals
  2. Brands
  3. Air-Vac Manuals
  4. Power Supply
  5. DRS24C Series
  6. Quick start manual

Air-Vac DRS24C Series Quick Start Manual

Motor driver replacement
Hide thumbs
1
2
3
4

Advertisement

Table of Contents

DRS24C Series

Motor Driver Replacement

Replacing your Z-axis or vision system motor
driver controller
☛
BEFORE YOU START:
Read instructions thoroughly before beginning.
ELECTRICAL WARNING:
POWER DOWN DRS24 AND DISCONNECT
FROM POWER SOURCE.
!
CAUTION:
OBSERVE PROPER STATIC PRECAUTIONS.
☛
NOTE:
The two motor drivers look the same, but they
are not interchangeable!
For technical problems, please contact the Air-Vac technical service department at:
e-mail: solder.tech@air-vac-eng.com • www.air-vac-eng.com • 03/26/01
Air-Vac Engineering Company, Inc.
30 Progress Avenue • Seymour, CT 06483
Phone: 203-888-9900 • Fax: 203-888-1145


CHECKLIST:

The following items will be needed in this section.
Metric Allen wrenches
American Allen wrenches
Vision driver part no. 9002.11.005
Z-axis driver part no. 9002.11.006
Section 1.0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DRS24C Series and is the answer not in the manual?

Questions and answers

Related Manuals for Air-Vac DRS24C Series

Summary of Contents for Air-Vac DRS24C Series

  • Page 1 NOTE: The two motor drivers look the same, but they are not interchangeable! For technical problems, please contact the Air-Vac technical service department at: Air-Vac Engineering Company, Inc. 30 Progress Avenue • Seymour, CT 06483 Phone: 203-888-9900 • Fax: 203-888-1145...
  • Page 2 DRS24 Technical Service Manual Section 1.0 : Motor Driver Replacement 1.0 Motor Driver Replacement IMPORTANT VERIFY DRS24 IS DISCONNECTED FROM THE POWER SOURCE. ☛ Both motor drivers are located in the DRS24 right box (A), (fig.1). NOTE Remove the 10/32” button head screw (B), (fig.1), and swing right box open. STEPS Fig.
  • Page 3 DRS24 Technical Service Manual Section 1.0 : Motor Driver Replacement Loosen, do not remove, the two M3x12 screws (F), (fig. 3), on each side of the driver you’re replacing. Slide driver to the left and lift out of machine. Fig. 3 Locate the new driver and remove plastic cover (fig.
  • Page 4 DRS24 Technical Service Manual Section 1.0 : Motor Driver Replacement Set the dip switches per (fig. 5) vision driver, or (fig. 6) Z-axis driver, depending on which driver you are replacing. ☛ NOTE On the dip switches, “Open” means “Off”. Slide cover back on driver and install driver back into machine.

Table of Contents