1. Manuals
  2. Brands
  3. Air-Vac Manuals
  4. Power Supply
  5. DRS24C Series
  6. Technical & service manual

Air-Vac DRS24C Series Technical & Service Manual

15v power supply replacement
Hide thumbs
1
2
3
4

Advertisement

Table of Contents

DRS24C Series

15V Power Supply Replacement

Replacing your 15V power supply
☛
BEFORE YOU START:
Read instructions thoroughly before beginning.
ELECTRICAL WARNING:
POWER DOWN DRS24 AND DISCONNECT
FROM POWER SOURCE.
!
OBSERVE PROPER STATIC PRECAUTIONS.
For technical problems, please contact the Air-Vac technical service department at:
e-mail: solder.tech@air-vac-eng.com • www.air-vac-eng.com • 03/26/01
Air-Vac Engineering Company, Inc.
30 Progress Avenue • Seymour, CT 06483
Phone: 203-888-9900 • Fax: 203-888-1145

CHECKLIST:
The following items will be needed in this section.
M4 Allen wrench
1/16" Allen wrench
Slotted screw driver
Black magic marker fine point
15V Power supply part no. 9002.10.010
Section 7.0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DRS24C Series and is the answer not in the manual?

Questions and answers

Related Manuals for Air-Vac DRS24C Series

Summary of Contents for Air-Vac DRS24C Series

  • Page 1 Black magic marker fine point 15V Power supply part no. 9002.10.010 CAUTION: OBSERVE PROPER STATIC PRECAUTIONS. For technical problems, please contact the Air-Vac technical service department at: Air-Vac Engineering Company, Inc. 30 Progress Avenue • Seymour, CT 06483 Phone: 203-888-9900 • Fax: 203-888-1145...
  • Page 2 DRS24 Technical Service Manual Section 7.0 : 15V Power Supply Replacement 7.0 15V Power Supply Replacement IMPORTANT VERIFY DRS24 IS DISCONNECTED FROM THE POWER SOURCE. ☛ The 15V power supply is part of the power module assembly, located in the right side NOTE of the DRS module (A), (fig.1).
  • Page 3 DRS24 Technical Service Manual Section 7.0 : 15V Power Supply Replacement From bottom of DRS24, remove the four M4 screws that hold the power module assembly in. CAUTION USE EXTREME CAUTION WHEN REMOVING SCREWS. Once the screws from step 4 are removed, slide the DRS24 off the bench in the direction of the X &...
  • Page 4 DRS24 Technical Service Manual Section 7.0 : 15V Power Supply Replacement Remove the 2 allen screws (D) (fig.3), that hold the 15V power supply (E) to the power module assembly (F). The 15V power supply will now come out. Remove the power supply toward the front of the DRS24.

Table of Contents