Subscribe to Our Youtube Channel
Related Manuals for XU1 XHG-503
Summary of Contents for XU1 XHG-503
- Page 1 XU1 Power tools 1–23 Letcon Drive, Bangholme, Victoria, Australia 3175 Telephone: 1800 069 486 XHG-503 1118...
- Page 2 1 Heat Gun Nozzle 4 Hanging Ring 7 Deflector Nozzle 2 On/Off Switch (Dual Heat Setting) 5 Power Cord 8 Reflector Nozzle 3 Handle 6 Cone Nozzle 9 Fishtail Nozzle...
-
Page 3: Specifications
Do not hold the nozzle too close to the • Loosening rusted or tightly fastened nuts and bolts wood as this will colour the wood unevenly. Carefully The XU1 heat gun is fitted with a thermal fuse which is sand off any singed wood fibres afterwards using fine • Removing paint and lacquer a one-time fusible link. The thermal fuse is a single-use sand paper. -
Page 4: Maintenance
Note: XU1 will not be responsible for any damage or injuries caused by the repair of the tool by an 1 YEAR REPLACEMENT WARRANTY unauthorised person or by mishandling of the tool. -
Page 5: Safety Instructions
SAFETY GENERAL POWER TOOL battery pack, picking up or carrying the tool. Carrying power tools with your finger on the SAFETY WARNINGS INSTRUCTIONS switch or energising power tools that have the switch on invites accidents. WARNING! Read all safety d) Remove any adjusting key or wrench warnings and all instructions. Failure WARNING! When using mains-powered before turning the power tool on. - Page 6 ADDITIONAL SAFETY DESCRIPTION OF SYMBOLS WARNINGS FOR HEAT GUNS Read instruction manual ALWAYS WEAR EYE, FACE AND Wear eye, breathing and hearing EAR PROTECTION protection R.C.M. Regulatory compliance mark WARNING! This appliance is not intended for use by persons Do not put in the rubbish (including children) with reduced physical, sensory or mental capabilities, Double insulated...
Need help?
Do you have a question about the XHG-503 and is the answer not in the manual?
Questions and answers