Table of Contents
Advertisement
3-2
Installation
3
Obtain or fabricate any necessary cables. Check the cabling guidelines provided in Appendix
B, "Cabling Specifications," for the length restrictions, connector, and cable or wire type for
each connection required for your system.
4
Brace the unit with optional rear supports for improved stability when mounting the
OM 1000 into the equipment rack.
Mounting the OM 1000
Mount the OM 1000 in a standard 19-inch rack. Provide an open space of 1.75 inches above and
below the unit to allow the free flow of air. If the equipment operates continuously in a closed
cabinet, use forced-air circulation to ensure maximum equipment life and optimum
performance.
CAUTION!
Improper grounding may damage the OM 1000. Refer to the national guidelines or local standards for the OM 1000
proper grounding to equipment racks and to the building grounding system.
To mount the unit in the rack:
1
Insert the four screws with the washers through the four mounting holes in the front panel
and into the mounting holes in the rack, as illustrated in Figure 3-1:
Figure 3-1
Rack mounting
2
Install the optional rear supports, if desired, (part # 213883-000) to improve stability.
3
Tighten all screws.
OM 1000 Installation and Operation Manual
Front
Rear supports
(part # 213883-000)
1.75"
spacing
Advertisement
Table of Contents
