Training instructions and limitations ...................... 7 Foreword Thank you very much for choosing the FitWood TROLLSTIGEN Wall Bars. Please read this guide thoroughly before assembly and follow each process step by step so you can enjoy the product safely. Note: Some steps may require two people.
Warranty Your FitWood product has up to 7 years (2 years + 5 years by registration) Warranty for home use and up to 2 years (1 years + 1 year by registration) Warranty for commercial use. In order to upgrade your Warranty and enjoy the extention, you should register your product at fitwood.com/register within...
Prepare for mounting on wall PLEASE NOTE: The mounting rails are 78 cm (30.7in) wide in order to accommodate studs that are 60 cm (23.6 in), or for unusual spacing. Before the assembly kindly check with the qualified person if Wooden screws 6 x 100, 4 pcs (included in the package) are suitable for your wall material.
Assembly instructions for TROLLSTIGEN Wall Bars Step 1 GENERAL: Always fasten the screws slowly and firm. However, do not mount the screws deep tight. Remember, that material is wood, and may crack if you are using too much power. Once the Wall Bars are fully assembled, check that all the screws are fully fastened.
Page 6
Turn the Wall Bars front side downwards. Screw the mounting boards into a place with eight (8 pcs) 6 x 60 TX 30 screws (same screws as for the long side rails). Assemble the mounting rail with FITWOOD logo to the upper section, and the board with TROLLSTIGEN logo to the lower section.
We keep on updating training instructions on our website. Feel free to visit our website at www.fitwood.com to learn more. You will also see how to combine other FitWood products, such as Gym Rings, to TROLLSTIGEN Wall Bars for more effective training.
Need help?
Do you have a question about the TROLLSTIGEN WALLBARS and is the answer not in the manual?
Questions and answers