HelixNet
INDUSTRIAL KB STATION
Quick Start Guide
The following Quick Start Guide provides basic instructions for your HelixNet 2.1 system. It covers the following:
HelixNet INDUSTRIAL KB STATION (IKB-12P)
HelixNet 2.1 topology
For more information, see the HelixNet 2.1 (IKB-12P) INDUSTRIAL KB STATION User Guide.
Note:
1.1 Installing the KB Station
The station can be installed either:
Mounted in an enclosure for desktop use
Mounted inside a wall box.
There are four mounting holes (A) located at each
corner of the unit that enable you to fix the unit to your
existing desktop or wall-hanging enclosures.
Ensure that a handset is connected to the handset
connector (B).
By default, DHCP is enabled and the station
automatically pairs to the first HMS-4X Main Station it
finds. You can change this setting in the Networking
menu.
1.2 Configuring the KB Station
To place the INDUSTRIAL KB STATION in Menu
Mode, or exit Menu Mode, press the Rotary Control
(B) for approximately four seconds. Use the OLED
Menu Displays (A) as follows:
To navigate up or down the list of menu
options, turn the Rotary Contro
or counter-clockwise respectively.
To select a menu option, or to open a list of
submenu options, briefly press the Rotary
Control.
To return to the previous menu, press the
Rotary Control for approximately 0.5 s.
Note:
Note: You can also configure the KB Station using the
browser-based Configuration Editor. For more
information, see the HelixNet 2.1 (IKB-12P)
INDUSTRIAL KB STATION User Guide.
1
399G167 Rev: 1 1/13/16
®
2.1
l
clockwise
Need help?
Do you have a question about the HelixNet IKB-12P and is the answer not in the manual?
Questions and answers