Mahindra Genio DC BS-III Diagnostic Manual page 9

Diagnostic Manual
Genio DC - BS III & BS IV
Key Assignment Process
• Customer Verification
Key
Request
• Order new key using the Duplicate Key Request (DKR) process.
Key
Order
• Select "Key Programming"
•SMART tester will generate Tool Programming Key-1 - Valid for 48 hours.
TPK1
•Raise a TAR along with
• TEKline will provide
• ASC1 is valid until TPK1 is valid.
ASC1
• Based on the ASC1, reassign key. SMART tester will generate
Key – 2 (TPK2)
TPK2
• TPK2 to be provided to TEKliner
• TEKline will provide
ASC2
• CoTEK will enter the ASC2 and complete the Key assignmnet session
• Close TAR
Finish
Important Note -
1. Whenever the key is replaced and if the vehicle is with keyless entry then
the remote learning has to be performed
All copyrights reserved by
The repair methods given by the manufacturer in this document are based on the technical specifications current at the time of release. The methods may be modified as a result of changes introduced
by the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part or whole of the
present document, are prohibited without the prior written consent of
(Immobiliser)
Tool Programming Key – 1 (TPK1)
After Sales Code - 1 (ASC1)
After Sales code -2 (ASC2)
Mahindra & Mahindra Ltd.
MAN-00138-
August 2011/Rev 1
based on TPK1
Tool Programming
9