Mounting Tyre - LAUNCH TECH LAUNCH TWC-401NIC Manual

LAUNCH
Fig.12
Fig.14
If there is tube in the tyre, remove it.
Lift the lower tyre bead after removing the tube from
the tyre so that the rim at the relative side enters the
groove(Fig.14). Depress pedal H (Fig.07) to loose
the jaw and take the rim off to complete the
demounting
Fig.11
Fig.13
Caution:
Keep hands and the rest of human body away from
the moving parts of the machine. Never wear necklace,
bracelet or loose clothes when operating the machine
as it may cause danger!

Mounting tyre

Note:
Check the size of tyre and rim to see if they match
each other.
Clamp the rim tightly in the same way as demounting
tyre.
Use lubricant such as thick soap solution on the tyre
and the rim.
Put the bead on the rim with the left side upward,
and pull back the mount/ demount head to the work
position (Fig.15)
Check the coordination of mount/demount head and
rim. Readjust if necessary.
Adjust relative position between the tyre and the
mount/demount head to make the tyre bead cross
the mount/demount head. At the end of the
mount/demount head, the tyre bead should be
placed on the mount/demount head (Fig.16A). At the
beginning of the mount/demount head, the tyre bead
should be placed under the ball protuberance of the
mount/demount head (Fig.16B).
Press down the central part of the tyre. Depress the
pedal J (Fig.12) to turn the turntable clockwise,
5
Tyre Changer (TWC-401NIC)
Fig.15
Fig.16