Hydronic Module Components; Kits Available On Request - Immergas MAGIS PRO ERP Instruction And Recommendation Booklet

1.15 HYDRONIC MODULE COMPONENTS.

1-11
Key:
1 - Domestic hot water inlet valve
2 - System filling valve
3 - 3-bar safety valve drain fitting
4 - Inspectable filter
5 - 3 bar safety valve
6 - Hydronic unit circulator
7 - Vent valve
8 - Liquid phase detection probe

1.16 KITS AVAILABLE ON REQUEST.

• 3 kW heating system integrated resistance
kit. Should it be necessary, you can install an
electrical resistance to supplement the central
heating system; this resistance can be installed
directly inside the hydronic module.
• 2 zone kit (1 direct and 1 mixed). Should it be
necessary, you can install the zone kit, which
allows you to divide the heating system into
two separate zones - one direct and one mixed.
• Configurable relay interface kit. The module
is set up for a relay board, which amplifies the
9 - System expansion vessel
10 - Flow probe
11 - Plate heat exchanger
12 - Vent valve
13 - Central heating integrated electrical
resistance cap (optional)
14 - Central heating manifold
15 - System flow meter
16 - Return probe
17 - By-pass
appliance features and, thus, the operating
possibilities.
• 2 relay board kit. The hydronic module can
manage up to two dehumidifiers. A 2 relay
board that manages dehumidifier enabling is
available to pair the appliances.
• R410A circuit connection kit. For R410A
circuit wall connections, there is a kit with the
two pipes necessary to create the circuit.
13
18 - Three-way valve (motorised)
19 - System draining valve
20 - System cut-off tap
21 - System cut-off tap
The above-mentioned kits are supplied complete
with instructions for assembly and use.