Table of Contents
Advertisement
Problems and solutions · Cleaning · Technical specifications
The subwoofer is not working
If the Power LED on the rear panel does not light
up, replace the fuse (see page 14, point 11). If the
Power LED lights up, set the subwoofer volume
level to "Min" , unplug the subwoofer cinch cable
from the amplifier, turn up the volume slightly
and touch the tip of the cinch connector with
your finger. If this produces a hum or crackle, the
fault is with the amplifier or the amplifier set-
tings. If the subwoofer remains completely silent,
please contact our support team.
The subwoofer is making a humming noise
Hum may be caused by any connected audio de-
vice as well as by problems with the mains power.
In most cases, excessive hum is caused by one of
the following:
1. The subwoofer is connected to a different
electrical circuit than the other components.
Make sure that all the connected devices (in-
cluding any computers) are powered from the
same electrical circuit, i.e., the same mains
socket.
2. The antenna connected to the audio sys-
tem or TV has a different ground potential to
the antenna socket. To test this, simply discon-
nect all the antenna cables from the wall socket.
If this makes the hum disappear, you will need a
ground breaker (available from most electronics
stores). Simply insert the ground breaker be-
tween the antenna socket and the TV/receiver.
Cleaning
Please take note of the following guidelines to
protect the components and maintain the finish
of your Teufel loudspeakers:
Avoid placing the speaker cabinets in direct sun-
light. Avoid extreme temperature fluctuations
and protect your loudspeakers against humidity.
When cleaning the speaker cabinets, only use dry
or moist cloths. Never use abrasive or alcohol-
based cleaning products. If you need to clean a
speaker membrane, do so very carefully using a
dry cloth.
3. A line filter (to be purchased separately) can
also be useful for hum removal. Note that you
will need to connect all your electrical devices
to the line filter. Make sure you can return the
line filter for a refund if it does not produce
the desired results.
4. Some types of power multiboxes are also
known to produce hum. Try eliminating your
multibox and plug the subwoofer's power cable
directly into the mains socket.
5. If possible: Unplug the mains cable, rotate
the connector plug by 180° , and plug it back
into the mains socket.
6. If you have trouble locating the source of the
hum, check whether the subwoofer is less noisy
when you plug it into the mains connection in
another room (e.g., using an extension cable).
Also, try disconnecting the subwoofer's cinch
cable from the receiver to see whether the hum
is caused by one of the other connected audio
devices.
The M 2200 SW is switching itself off
For safety reasons, the M 2200 SW is equipped
with an automatic disable switch.
This is designed to protect the power supply, the
amplifiers and the speaker from overloading.
Whenever the subwoofer is pushed beyond its lim-
its, the disable switch is activated. For example,
this may happen if the subwoofer is placed in a
very large room and is run continuously at a very
high volume with the "Bass Boost" control right
down on 25 Hz. Use the "Power Function" switch
(On – Auto – Off ) to reactivate the subwoofer.
Technical specifications
All technical specifications are listed on our
website at www.teufel.eu
Teufel · Theater 2
15
Advertisement
Table of Contents
