Advertisement
Paso 10. Conexión de la pantalla al pie
A.
Enrosque la Pantalla de la UAL (P)
en la UAL. No apriete los tornillos de-
masiado. Deje unos 6 mm (1/4") de espacio.
B.
Coloque la UAL en la cabeza de apoyo.
C.
Inserte dos tornillos de la UAL adicionales a
través de las arandelas y la cabeza de apoyo en la
UAL.
Step #2: Attaching Mounting Post to Base
A.
Insert the Mounting Post into Base
B
. Lean the stand forward. Thread
the four Base Screws through the
Base Washers and into the Base.
C
. Tighten all Screws securely
Step #3: Shelf Assembly
A.
Loosely thread two Shelf Screws through each Shelf Bracket and into two Shelf
T-Bars.
B.
Slide both Shelf Bracket Assemblies
into the Mounting Post. Then slide them
into the desired position, and, using the
supplied Hex Wrench, tighten both Shelf
Bracket Assemblies. (The Shelf T-Bars
will turn to the right once they are inside the
Mounting Post and you begin tightening
the Screws. When they tighten, they will
grab the inside rails of the Mounting Post
Channel.)
NOTE: Ensure that the Shelf
Bracket is installed with the
notched hole on top and facing
the outside.
A.
B.
A.
B.
Advertisement
