Advertisement
3. ASSEMBLY
Unpack the lift and check contents with the parts list. Should there be any damaged or missing parts contact your supplier immediately.
WARNING! Keep your hands away from moving parts.
3.1.
Assembly.
MC455 comes largely assembled, follow the diagram below to attach the front wheel mount, handle etc. Check all fixings to ensure none are
loose. Check that the locking mechanism (13) operates freely, so as the table is raised, the lock drops down into the locking position.
3.2.
Before first use.
3.2.1. Leave the pump for one hour, to allow the oil to settle, before purging the system.
Note: Failure to allow sufficient time for the oil to settle could result in air remaining in the oil. In this event, the pump will not purge
completely first time and a second purge will be required.
3.2.2. Purge the hydraulic circuit to eliminate any air in the system, by fully pressing the release valve pedal and pumping the lift pedal
(17) 15 to 20 times.
3.2.3. Test the lift, unladen, by raising it to full height and then lowering it. Depress release valve pedal slowly to control the rate of descent.
Foot Pedal
Release Pedal
Front Wheel
Support
Safety Lock
Anti-Roll Locks
Original Language Version
Strap Hooks
MC455
Issue: 2 - 01/06/11
Advertisement
