Table of Contents
Advertisement
Using the wired remote control mode
Connect the supplied remote cable to the remote
controller's remote jack and the "REMOTE CONTROL"
terminal on the display.
When the cable is connected, the mode automatically
switches to wired remote control. When the wired remote
control mode is used, the remote controller can be operated
even if no batteries are loaded.
VIDEO 1
VIDEO 2
L ( MONO )
R
Y
CB / PB
CR / PR
L ( MONO )
R
RGB 1
R / CR / PR
G / Y
/ VIDEO 3
B / CB / PB
HD
VD
L ( MONO )
R
CONTROL
LOCK
ON /
OFF
RGB 3
( D i g i t a l RGB )
REMOTE
CONTROL
EXTERNAL
CONTROL
R
CONTROL
LOCK
ON /
OFF
REMOTE
CONTROL
EXTERNAL
CONTROL
Remote Control
Cable
To Remote Jack
11
Operating Range
• Use the remote controller within a distance of about 23ft /
7 m. from the front of the display's remote control sensor
and at horizontal and vertical angles of up to approximately
30°.
• The remote control operation may not function if the
display's remote control sensor is exposed to direct
sunlight or strong artificial light, or if there is an obstacle
between the sensor and the remote controller.
PROCEED
DOWN
VOLUME
UP
LEFT/ -
RIGHT/+
INPUT SELECT / EXIT
Approx.
23ft / 7m
Handling the remote controller
• Do not drop or mishandle the remote controller.
• Do not get the remote controller wet. If the remote
controller gets wet, wipe it dry immediately.
• Avoid heat and humidity.
• When not using the remote controller for a long period,
remove the batteries.
• Do not use new and old batteries together or use different
types together.
• Do not take apart the batteries, heat them, or throw them
into a fire.
• When using the remote controller in the wireless
condition, be sure to unplug the remote cable from the
REMOTE CONTROL terminal on the display.
POWER/STANDBY
Advertisement
Table of Contents
