Installation; To Connect The Antenna; To Prepare The Remote Control - Toshiba 32JW8UA Owner's Manual

INTRODUCTION

Installation

• INSTALL the TV in a room where direct light will not fall upon the screen.
Total darkness or a reflection on the picture screen may cause eyestrain. Soft and indirect lighting is
recommended for comfortable viewing.
• ALLOW enough space between the TV and the wall for proper ventilation.
• AVOID excessively warm locations to prevent possible damage to the cabinet or components.
• RATED VOLTAGE:

To connect the antenna

Optimum reception of color requires a good signal and will generally mean that an outdoor antenna must be used. The
exact type and positioning of the antenna will depend upon your particular area. Your Toshiba dealer or service
personnel can best advise you on which antenna to use in your area.
300-ohm twin-lead feeder
Antenna adaptor
(not supplied)
75-ohm coaxial cable
75-ohm
Plug
antenna
(not supplied)
terminal

To prepare the remote control

Battery installation
Remove the battery cover.
Insert two R03/AAA batteries matching the –/+ polarities
of the battery to the –/+ marks inside the battery
compartment.
Caution:
• Dispose of batteries in a designated disposal area. Do
not throw batteries into a fire.
• Do not mix battery types or combine used batteries
with new ones.
g 220 – 240 V, 50 Hz.
75-ohm
antenna
terminal
VHF and/or UHF antenna
Wall AC output
Notes
• It is recommended that the 75-ohm coaxial cable be
used to eliminate interference and noise which may
occur due to radio wave conditions.
• The antenna cable should not be bundled with the
power cord and the like.
Tips for best operation
Effective range
Notes:
• If the remote control does not operate correctly, or if the
operating range becomes reduced, replace both batteries
with new ones.
• When the remote control will not be used for a long period
of time or when the batteries are worn out, remove the
batteries to prevent leakage.
• Do not drop dampen, or disassemble the remote control.
7