Programming The Remote Control To Operate Your Other Devices - Toshiba 27AF46C Owner's Manual

To control a cable TV
converter:
Program the remote
control to recognize the
brand of your converter
(see "Programming the
remote control to operate
your other devices"
below). The buttons
shown at right will control
the cable TV converter.
Press the CABLE button
first.
Programming the remote control to operate
your other devices
This remote control is pre-programmed to operate Toshiba VCRs and
DVD players. To control VCRs, DVD players, or cable converters other
than Toshiba models, you must follow the steps below to program your
remote control.
1. While holding down the CODE button, press the button for the
device you want to control (VCR, DVD, or CABLE).
2. Enter the 2-digit code listed on page 13 using the Number buttons
(0–9) within 10 seconds.
3. Point the remote control at the VCR, DVD player, or converter and
press POWER to test the code.
If the VCR, DVD player, or converter turns on, you have entered
the right code.
If the VCR, DVD player, or converter does not respond to the
remote control, you may have entered the wrong code. Repeat
steps 1 and 2 using another code.
For future reference, write down the codes you used:
VCR code ________________________
DVD player code ___________________
Cable TV converter code ____________
J3N12621A(E)_P07-16
CABLE
POWER
TV
Power
1 2
4 5
Channel
Numbers 7 8
VOL
MENU/
–
ENTER
Channel +/–
EXIT RECALL
CH RTN
VOL
RESET CAP/TEXT
DISPLAY DVD CLEAR
CODE MTS
REW PLAY
TV/VCR STOP
REC
12
VCR CABLE
DVD
3
+10
6 100
9 0
CH +
VOL
+
CH –
TV/VIDEO
FAV
CH RTN FAV
16:9
1/2
TOP MENU DVD MENU
SLEEP MUTE
FF
PAUSE/STILL
VCR CH
DVD SKIP
Notes:
• When shipped from the factory, the remote
control is set to operate your TV.
• If you do not enter the code within 10
seconds from step 1 or if you enter a code
not listed on page 13, this operation is
canceled.
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled "VCR1/VCR2."
If your VCR has this kind of switch and
does not respond to any of the codes for
your VCR, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
12
6/12/05, 9:47 AM
VCR
POWER
TV VCR CABLE
CABLE
DVD
1 2 3 DVD
+10
4 5 6 100
7 8 9 0
CH +
VOL VOL
MENU/
+
–
ENTER
CH –
EXIT RECALL TV/VIDEO FAV
VOL CH RTN FAV
16:9
RESET CAP/TEXT 1/2
DISPLAY DVD CLEAR TOP MENU DVD MENU
CODE MTS SLEEP MUTE
Code
REW PLAY FF