Notes On The Documentation; Attachment And Storage Of The Documents; Symbols Used; Ce Label - Vailant ecoLEVEL Operating Manual

Table of Contents

Available languages

Enlarged version

1 Notes on the documentation

2 Safety instructions and regulations

Notes on the documentation

The following information is intended to help you

throughout the entire documentation.

Further documents apply in combination with this oper-

ating, installation, and maintenance manual.

We accept no liability for any damage caused by non-

observance of these instructions.

Attachment and storage of the documents

Please pass on this operating, installation, and mainte-

nance manual to the owner of the system. The owner

shall ensure that the manuals are properly stored so

that they are available whenever required.

1.2

Symbols used

Please observe the safety instructions in this manual

when installing or servicing the condensate pump.

Danger!

Risk of fatal electric shock!

Danger!

Immediate risk of serious injury or death!

Caution!

Potentially dangerous situations for the prod-

uct and environment!

Note!

Useful information and instructions.

• Symbol for a necessary task

1.3

CE label

CE labelling shows that the ecoLEVEL condensate pump

complies with the requirements of the following applica-

ble directives as stated on the data badge:

- Permissible voltages (directives EN 60 335-1 and EN

60 335-2-41)

- Electromagnetic compatibility (directives EN 55 014-1

and EN 55 014-2)

1.4

Data badge

The data badge which lists the serial number, protection

class, supply voltage, the frequency, and the CE label, is

located on the underside of the ecoLEVEL condensate

pump.

1.5

Applicability of the manual

These installation instructions apply exclusively for

appliances with the following part numbers:

- 306287

The article number of the unit can be found on the iden-

tification plate.

Safety instructions and regulations

Danger!

Danger of death due to high voltage!

Lethal voltage is present in both the appliance,

and the power supply lines. For this reason, the

appliance may only be installed or opened by a

heating engineer.

Standards and regulations

IEC 60364-7-712 Electrical installations of buildings -

Part 7-712

EMV test procedures in accordance with EN50081-1:1992,

EN50082-1:1997

Emission interference: EN 55014-1: 1993

Interference resistance: EN 55014-2: 1997

Engineering rules

The installation must correspond to the site conditions,

to local regulations and, last but not least, to the engi-

neering rules.

Accident prevention regulations

The condensate pump must be installed by a suitably

qualified heating engineer, who is responsible for the

observance of all applicable standards and regulations.

Proper transport, appropriate storage, professional

setup and installation, as well as careful operation and

maintenance, are all prerequisites for the safe and sound

operation of the appliance.

Only heating engineers who are familiar with all of the

safety, installation, operation, and maintenance instruc-

tions contained in this operating and installation manual

may work on this appliance.

When the appliance is operating, some components con-

tain dangerous levels of voltage which can result in seri-

ous bodily injury or death.

The following safety precautions must be taken in order

to minimise the danger of serious injury or death:

1. The appliance must be installed in accordance with

safety regulations, as well as all other relevant local or

state regulations. Proper grounding, adequate electri-

cal wiring, and sufficient short circuit protection must

be provided in order to ensure safe operation.

2. The bottom cover should only be opened by a qualified

heating engineer.

The floor cover may only be opened if all electrical

connections are disconnected from the pump.

3. Ensure that the power supply has been switched off

and secured against reconnection before conducting

Installation and maintenance manual ecoLEVEL 0020010507_02

Table of Contents

Chapters

Table of Contents