Advertisement
LAUFEN
CITY PLUS SHOWER/BATH MIXER
SPECIFICATIOnS
Domestic, Hotel and Commercial
Recommended use
Colour availability
Chrome
Pressure rating
Maximum continuous operating pressure 1000kPa.
As per AS/NZS3500 pressure must be limited to
500kPa on any new home, extension or renovation.
For best performance and longer life we recommend
150-500kPa.
Hot and cold water inlet pressure should be equal.
Temperature rating
Maximum continuous working temperature 80°C
Suitable Hot Water
Storage Tank: Yes
Units
Continuous Flow: Yes
Gravity Feed: Not suitable
CLEAnIng RECOMMEndATIOnS
We recommend the use of soapy water or approved cleaners.
This product should not be cleaned with abrasive materials.
Damage caused by any improper treatment is not covered by the product warranty. Refer to Warranty Conditions.
TM
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered
trade people. The manufacturer/distributor reserves the right to vary specifications or delete models
from their range without prior notification. Dimensions are nominal measurements only. Dimensions are
nominal measurements only. Dimensions and set-outs listed are correct at time of publication however the
manufacturer/distributor takes no responsibility for printing errors.
AS/NZS 3718
WMK25894
Tech Page Version 1
Dimensions are nominal measurements only.
To see the complete LAUFEN range go to
www.reece.com.au/bathrooms
page 1 of 4
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Laufen CITY PLUS
Summary of Contents for Laufen CITY PLUS
- Page 1 Storage Tank: Yes Units Continuous Flow: Yes Gravity Feed: Not suitable To see the complete LAUFEN range go to www.reece.com.au/bathrooms CLEAnIng RECOMMEndATIOnS We recommend the use of soapy water or approved cleaners. This product should not be cleaned with abrasive materials.
-
Page 2: Installation Instructions
2 of 4 LAUFEN CITY PLUS SHOWER/BATH MIXER Important note Mixer must be installed to the requirements of AS/NZS 3500 by a qualified plumber. Your mixer comes to you already factory assembled and tested. We do not recommend the dismantling of any internal part of the mixer. The mixers are factory tested and sealed so as to give the best performance. - Page 3 3 of 4 LAUFEN CITY PLUS SHOWER/BATH MIXER 6 Nm +/- 1 Nm Tighten the 2 screws parallel (1 turn each side) Check before installation that all seals are available and at the right place Plumbers, please ensure a copy of the installation...
- Page 4 4 of 4 LAUFEN CITY PLUS SHOWER/BATH MIXER Examples of how to fit the decorative elements Before installing the decor, open the valves check for water tightness. Only for Simibox Light without stop valves Plumbers, please ensure a copy of the installation...
Need help?
Do you have a question about the CITY PLUS and is the answer not in the manual?
Questions and answers