How To Perform Cabling Of The Signal Receiving Unit - Toshiba TCB-AX21UL Installation Manual
Remote controller for air conditioner (split type)
Hide thumbs
Also See for TCB-AX21UL:
- Owner's manual (20 pages) ,
- Owner's manual (20 pages) ,
- Installation manual (16 pages)
Table of Contents
Advertisement
Wireless remote controller kit
5
HOW TO PERFORM CABLING OF THE
SIGNAL RECEIVING UNIT
Flush Mounting
Connection diagram
Indoor unit remote
controller terminal
board
Wire of Signal receiving
unit (Field procurement)
(AWG20 (0.5 mm
(UL wires rated 300 V)
Provided wire joint (WHT 2)
1. Strip the insulation to approximately 0.55" (14 mm) from the ends of the wires to be connected.
2. Twist together the 2 wires and create a crimp connection at the wire joint.
3. If a special crimping tool is not used, or if the connection is soldered, insulate the wires using
insulation tape.
Exposed Mounting
• Connection diagram
Indoor unit remote
controller terminal
board
2
))
Connector
Wire of Signal
receiving unit
(Field procurement)
Power wire from
Signal receiving
unit
Remote controller cord (optional)
– 8 –
Signal receiving unit
Wire joint
(provided)
Signal receiving unit
Installation Manual
Power wire from
Signal receiving unit
EN
8-EN
Advertisement
Table of Contents
