Navini Networks Ripwave CPE Quick Installation Manual

Ripwave CPE Quick Installation Guide
Ripwave TM CPE Quick Installation Guide
The following instructions are for the experienced user as a quick setup
guide for the Ripwave unit. For more details on installation of the Ripwave
unit and software, see the Ripwave Unit Installation and User Guide.
Hardware Installation
1. Turn the computer off before installation. Connect the USB or Ethernet
cable to the Ripwave unit and to the corresponding port on the PC.
USB Cable
2. Connect the AC power adapter to the Ripwave unit and to a 110 VAC
outlet.
3. Rotate the antenna clockwise to the UP position.
4. Push the On/Off switch on the Ripwave unit to turn the unit ON. The
lower indicator light on the Ripwave unit illuminates green.
Power adapter
USB Port
Ethernet Port (2600E)
Ethernet Cable
AC power adapter
cable jack
On/Off Switch
Power adapter
USB Port
Ethernet Port (2400E)
5. Set the power switch on the computer to the ON position. When the
system is up, log in to the computer.
®
Note: For Windows NT and Windows
an account having administrative privileges to install the Ripwave unit
and its software.
6. For an Ethernet connection, go to the Ripwave Monitor Software
Installation section. For a USB connection, Plug and Play will detect the
new hardware – click Next in the Add New Hardware Wizard dialog box,
and continue on with the hardware installation.
7. Insert the Navini Networks Ripwave Installation CD in the CD-ROM
drive.
8. Follow the instructions for the 'Add New Hardware Wizard' to install the
device driver for the Ripwave unit.
9. Select the 'CD-ROM drive' checkbox. Click Next to continue.
10. Restart the computer, and proceed to the Ripwave Monitor Software
Installation.
Navini Networks, Inc.
cable jack
®
2000, you must be logged into