CASUALPLAY Baby Zero Plus Instructions Manual page 25

Disconnecting the BABY ZERO PLUS from the BASE FIX BABY ZERO PLUS
• Pull the release device found on the backrest of the Baby Zero Plus (fig.18). The
indicators on the front part of the base fix baby zero plus will turn red, indicating that the
seat has been correctly disconnected.
• Pull the seat upwards (fig.19).
Installing the Baby Zero Plus on the pushchair
This exclusive fastening system means that the Baby Zero Plus can be used on the
following pushchairs: Vintage, Vintage2, Vintage3, Jazz, S4, Downtown, S4-reverse,
S-twinner, Avant, Kudu and Kudu mood. For all of them the procedure to fit the Baby
Zero Plus is the following:
• Put the parking brake on.
• Place the Baby Zero Plus on the pushchair, facing backwards.
• Line the Unisystem fasteners on the Baby Zero Plus up with the slots (fig.20).
• Press downwards until it clicks fastened and a green signal appears in each of the
windows on the sides of the fasteners (fig.21).
• To take the Baby Zero Plus off, press and then release the red button on both fasteners
(red signal in the window) and pull upwards to release it from the pushchair chassis
(fig.22).
Using the Baby Zero Plus as a rocker
• Place the Baby Zero Plus on the floor on a flat surface.
• Move the handle to the rocker position (consult the section about how to adjust the
carrying handle). Make sure that it clicks into position (fig.5) (C).
• The Baby Zero Plus will move as your baby moves.
• The baby should wear the harness fastened and should never be left alone.
WARNING: Never leave the child unsupervised.
Using the Baby Zero Plus as a seat
• Place the Baby Zero Plus on the floor on a flat surface.
• Move the handle to the stability position (consult the section about how to adjust the
carrying handle). Make sure that it clicks into position (fig.5) (A).
• The Baby Zero Plus can now be used as a seat for the baby.
23 23