Advertisement
Square Mirror Installation
The Square Mirror Installation Instructions applied to the following models:
LS205CSMC/E
LS205CSMCB
1. Begin by determining the appropriate location and height. We recommend approximately
150cm from the floor if the mirror is to be used while standing, and 120cm from the floor if
used while seated.
2. Remove the unit from its packaging and lay it carefully on a stable surface on top of the
product bag so that it does not get scratched.
3. Remove screws A & B from the face plate using a Philips head screw driver. Separate
mounting plate C from face plate D. (See diagram below).
4. Using mounting template C determine the exact location for the magnifying mirror and mark
this onto the wall.
5. Caution: Check the internal wall location for structural strength. Injury to people or damage to
the mirror and/or mounting surface may result if mirror is pulled from the surface. To limit the
likelihood of such injury or damage, mount the mirror on a structural wall material that is
sound.
6. Drill holes and insert the wall plugs provided then proceed to mount bracket C to the wall.
7. For hard wired models refer to wiring instructions on page 5
8. Lift the magnifying mirror back onto mounting plate C so that face plate D is now sitting flush
against the wall.
9. Refit screws A & B and tighten to hold the magnifying mirror firmly to the mounting plate
10. For exposed wired (plug-in) models you can now plug the magnifying mirror directly into a
power point.
4
Advertisement
