Advertisement
Round Mirror Installation
The Round Mirror Installation Instructions applies to the following models:
-
L252CSMC/E
-
L253CSMC
-
L255CSMC/E
-
L155CSMC
1. Begin by determining the appropriate location and height. We recommend approximately
150cm from the floor if the mirror is to be used while standing, and 120cm from the floor if
used while seated.
2. Remove the unit from its packaging and lay it carefully on a stable surface on top of the
product bag so that it does not get scratched.
3. Remove nuts A & B from screws C & D. Separate mounting plate E from face plate F (see
diagram below).
4. Using mounting template E determine the exact location for the magnifying mirror and mark
this onto the wall.
5. Caution: Check the internal wall location for structural strength. Injury to people or damage
to the mirror and/or mounting surface may result if mirror is pulled from the surface. To limit
the likelihood of such injury or damage, mount the mirror on a structural wall material that
is sound.
6. Drill holes and insert the wall plugs provided then proceed to mount bracket E to the wall.
7. For hard wired models refer to wiring instructions on page 5.
8. Lift the magnifying mirror and slide screws C and D back through the face plate and fasten
in position with nuts A and B and ensure these are tight.
9. For exposed wired (plug-in) models you can now plug the magnifying mirror directly into a
power point.
3
- L258CSMC/E
- LR257CSM
- L252CSMCB
- L252GSMC
Advertisement
