Wireless Lan - Toshiba P200 Series User Manual

To connect the LAN cable, follow the steps below.
1. Turn off the power to the computer and to all external devices
connected to the computer.
2. Plug one end of the cable into the LAN jack. Press gently until you hear
the latch click into place.
3. Plug the other end of the cable into a LAN hub connector. Check with
your LAN administrator before connecting to a hub.
Disconnecting the LAN cable
To disconnect the LAN cable, follow the steps below.
1. Pinch the lever on the connector in the computer's LAN jack and pull
out the connector.
2. Disconnect the cable from the LAN hub in the same manner. Check
with your LAN administrator before disconnecting from the hub.

Wireless LAN

The wireless LAN is compatible with other LAN systems that comply with
the IEEE802.11a, 11b, 11g and Draft 11n wireless LAN standards.
It supports the following:
■
Automatic Transmit Rate Select mechanism in the transmit range of 54,
48, 36, 24, 18, 9, 6 Mbps for 802.11a/b/g and 802.11b/g wireless LAN
module.
■
Advanced Encryption Standard (AES) data encryption, based on 256 bit
encryption algorithm.
Wake-up on Wireless LAN is supported on certain Wireless LAN model
from Sleep/Hibernate mode in AC adaptor mode.
(depending on the model you purchased.)
■
Frequency Channel Selection (5 GHz and 2.4 GHz)
■
Roaming over multiple channels
■
Card Power Management
■
Wi-Fi Protected Access (WPA) data encryption
User's Manual
Connecting the LAN cable
Operating Basics
4-8