Table of Contents
Advertisement
Connecting the product to the One Connect
QP82R-8K
QP82R-8K
One Connect
One Connect
One Connect
10 cm
Bending Cover
x 1
(M4 x L12)
One Connect
Connect the product and One Connect referring to the image.
1
Following the steps 1-4 in the image, use One Invisible Connection to connect the product
and One Connect.
2
Use the power cable to connect One Connect to a wall outlet as shown in step 5.
•
Do not install the One Connect upside-down or standing upright on one of its
sides.
•
When connecting the One Invisible Connection, use a Bending Cover to bend
the cable. The Bending Cover prevents the cable of the One Invisible Connection
from being bent at a 90 degree angle. Bending the cable at a 90 degree angle
can damage the cable.
•
When connecting the One Invisible Connection, pay attention to the shapes and
sizes of its connectors so that they are connected correctly. Failure to do so may
cause product malfunction.
•
When connecting the One Invisible Connection, be careful not to twist the
cable of the One Invisible Connection. Failure to do so may cause performance
degradation of the product or damage to the cable.
•
When arranging the remaining cable, refer to the figure
arrangement.
•
Take care not to subject the cable to any of the actions below. The One Invisible
Connection contains a power circuit. You could damage the cable and subject
yourself to an electric shock.
Bending
Twisting
CLASS 1 LASER PRODUCT (One Invisible Connection)
•
Caution - Invisible laser radiation when open. Do not stare into beam.
– Do not bend the One Invisible Connection cable excessively. Do not cut the
cable.
– Do not place heavy objects on the cable.
– Do not disassemble either of the cable connectors.
•
Caution - Use of controls, adjustments, or the performance of procedures other
than those specified herein may result in hazardous radiation exposure.
for the correct
Pulling
Pressing on
Electric shock
6
Advertisement
Table of Contents
