VEF TA-901 Quick Start Manual

VEF TA-901

FEATURE LIST:

FSK/DTMF System Caller ID Phone.
•
900 MHz Operation Frequency Cordless Telephone.
•
40-Channels Auto-Scanning or Manual Selectable.
•
65.536 Automatic Digital Security Code.
•
Store Up To 64 Caller ID Memories.
•
16 Type Ringer Melody and ringer ON/OFF.
•
4-grade LCD Brightness Can be Adjust.
•
Receiver volume high/low selection.
•
Review the Caller ID List to Dialing Back.
•
Pre-Dialing with Clear LCD for Handset.
•
Caller Number, Time and Date Display.
•
Flash and Pause button.
•
Last Number Redial Function.
•
Low battery Indicator on LCD.
•
Charge / Power LED Indicator.
•
Tone/Pulse Dial mode selector on the Base unit.
•
LOCATION OF CONTROLS:
LCD DISPLAY
REDIAL BUTTON
FLASH/CLEAR
BUTTON
UP BUTTON
SET BUTTON
MEMO
MIC.

INSTALLATION

1. Open the battery compartment cover at back of Handset load in recharge battery.
2. Connect the telephone wire to the telephone set and wall jack.
3. Connect DC 9V adapter to the phone set and the AC socket.
NOTE: If the power of battery is low, the low battery icons will appear on LCD, must recharging them soon.
The Battery must be charged for full 12 hours before the cordless phone is used for the first time.
SETUP THE TELEPHONE
65.536 AUTOMATIC DIGITAL CODE SECURITY
Many cordless telephones operate similarly and on the same frequency without digital code security. Another
cordless Handset could make calls using your Base and telephone line. Therefore to avoid any unauthorized
calls through your Base, a Digital code feature was added to your Cordless phone. This Digital Code is
shared only between the Handset and Base.
SET UP SECURITY CODE
1. Press and hold PAGE button on the base for more than 3 second.
2. Press Channel button (↑) on the handset to set Security Code.
3. When you hearing continuous beep tone. The Digital Code is reset randomly to one of more than
65,536 codes.
4. Release the PAGE button on base unit.
NOTE: If you hearing 2 different beep tone, the security code may be not set properly, must reset it again.
SET UP YOUR AREA CODE
1. Press " " or "
button.
2. The display show: OFF, press "
3. If you set ON, press SET button once more and key in you desired local area code, press SET button to
confirm.
SET UP THE TIME & CLOCK
1. Press " " or "
RECEIVER
OK BUTTON
C RD OK
ABC DEF
JKL MNO
GHI
PQRS TUV WXYZ
DOWN BUTTON
SET M+
CHANNEL BUTTON
CID BUTTON
" button to view the main menu, and LCD display "LOCAL" and blink, press SET
" or "
" button to view the main menu, until LCD display "CLOCK" and blink, press SET
CHARGE
" button to set ON or OFF.
LCD DISPLAY
12-12-00
DUAL LCD
CHARGE INDICATOR
POWER INDICATOR
PAGE
POWER
PAGE BUTTONS