Maintenance; To Remove Turntable - Garrard 210 Operating Instructions Manual

Note:
The pickup arm will not automatically move from its rest unless one or more records are
loaded on the record spindle. This is a safety measure to prevent damage to the pickup by
inadvertently switching on.
To play 7" 45 r.p.m. records having the large centre hole, use large record spindle type
LRS4/W obtainable as an optional extra. Alternatively, clip-in centre hole adaptors may be
used, these are obtainable from your record store.
To obtain the best results from your records see that they are stored and cleaned as recom-
mended by the record manufacturers. Do not leave records on the changer when not in use.
Installation:
When your Radiogram is installed, check that the two transit screws are removed and that
the changer is floating freely on its suspension springs. The transit screws are copper plated
for identification and their position is shown on diagram. Also see that the record selector
arm is in the vertical position as shown.
Maintenance
The motor turntable spindle and intermediate wheel bearings are of the oil retaining type
and rarely need lubricating. When the need for oil is apparent, remove the turntable and
lubricate these bearings with a fine grade of machine oil. Carefully remove all traces of
surplus oil—especially from the motor pulley and rubber intermediate wheel.
To remove turntable:
Remove turntable retaining clip and lift with equal pressure on diametrically opposite sides.
If difficulty is experienced give the record spindle a light downward tap with a piece of
wood, such as the handle of a screwdriver, while lifting the turntable.
Page Four